In this video, I insulate a small Ford Connect van in preparation of turning this Ford Connect LWB high top van in to a lovely little small micro camper van conversion. When I purchased the van, the previous owner had started some conversion work before stopping so the van already has a full later of bubble foil insulation throughout the interior of the van. The bubble foil insulation is good but not good enough so I proceed to install additional 25mm Celotex insulation in all of the panel voids in the van along with the rear doors and roof lining. The foil backed insulation boards are stuck over the bubble foil insulation and held in place with aluminium backed foil tape. I also lay a layer of foil backed flooring insulation on the plywood floor to give the flooring some additional insulation in preparation of laying some new Altro safety flooring in an upcoming episode.
Consider supporting the channel by becoming a member:
/ @thecampervanbuilder
Social:
Visit My New Website The Campervan Builder
www.thecampervanbuilder.com
Consider Supporting My Channel Via Patreon:
/ thecampervanbuilder
Follow My Facebook Page:
/ thecampervanbuilder
Follow My Instagram Page:
/ thecampervanbuilder
Watch me gaming on Twitch
/ sargentmajormonkey
Do you have a cool campervan you would like featured on the channel? Contact me at
TheCampervanBuilder@hotmail.com
Негізгі бет Insulating A Ford Connect Micro Campervan Conversion Build
No video
Пікірлер: 12