It has been brought to my attention that the op amp in the picture is flipped 180 deg from what I think it is. Please note that pin 1 is on the lower left corner, not the upper right!!
ALSO,
You do not need to sand your plates! I did, but it was something I should not have done. Sanding the plates was the first thing I did to try and solve the issue. As I learned more about the process of how these plates are made, I learned that just jumping out the 91 code is fine. That being said, the plates will need replaced eventually even after jumping out the 91 code, as the material on the plates that allows the chlorine to be efficiently generated does eventually wear off. I really need to delete these videos and start over with a new video with better explanations, but, I am not taking my chlorinator apart again just to make a vid.
Link to part 1
• Episode 2 | Ender 5 Mu...
Special thanks to John B for providing the pictures!!
In this video I give information that will work on all models. Just look for the IC chips that I show here on your model and you will be able to fix this issue!
If you are not comfortable fixing your system and want to send me your Intex chlorinator to be fixed, you can! Just email me that you would like to have your system fixed. I charge $45, and that includes parts. You pay shipping in both directions.
These chlorinators are designed to last about 2 years and generally fail in the 3rd season of use. The potentiometer I use is a 10k pot. I forgot to add this.
Before closing up this unit, I did apply hot glue to the the knob of the potentiometer to make sure it would not move. The method I show here allows all the functionality of the system including the self clean mode which is important for keeping the erosion of the plates even, plus keeping them clean. The most important function of this controller is to switch the polarity of the plates so that the plates do not become completely oxidized causing a high resistance between the plates, which mean no more chlorine generation. I also sanded my plates with 60 grit sandpaper. It is important to make sure that the plates are bare and free from debri caused by electroplating. So, it is important to sand in-between the plates once in a while. Using vinegar alone is not enough!!!!!!
If any one needs help with this or has further questions, feel free to contact me in the comments!
Thanks for watching!!
1jeredadams@gmail.com
Негізгі бет Intex Chlorinator Part 2 | Error 91 Low Salt Fixed by an Electrical Engineer | Questions Answered!
Пікірлер: 35