Intex Excursion5 Modification Project (Part 2), DIY launch dolly for Intex Excursion 5 inflatable raft boat. Budget around $50.
Building Materials:
Wheel (7" x 1-1/2"): amzn.to/3wyqv2T
Matel rod axle (1/2" - 13 x 24"): amzn.to/3AR93dh or low.es/2T2HYCL
PVC pipe (3/4" x 10ft): low.es/3B1sZdJ
PVC Tee threaded (3/4"): low.es/3k6WtAF
PVC Tee (3/4"): low.es/3AU8nE7
PVC adaptor (3/4"): low.es/3ASEZxR
PVC end cap (3/4"): low.es/3xuS26y
Hex nuts (1/2"): lowes.com
Lock nuts (1/2"): lowes.com
Flat washer (1/2"): lowes.com
Lock washer (1/2"): lowes.com
Foam pipe insulation: amzn.to/3k6VAIh
Zip ties (11"): amzn.to/2VrUpJb
plus:
PVC primer + cement: amzn.to/3i0RGy8
Other related videos in this series:
Intex Excursion5 (Part 0) - Unboxing: • Intex Excursion5 (Part...
Intex Excursion5 (Part 2) - Test on Water: • Intex Excursion5 (Part...
Intex Excursion5 (Part 3) - Trolling Motor: • Intex Excursion5 (Part...
Intex Excursion5 (Part 4) - Motor in Water: • Intex Excursion5 (Part...
Intex Excursion5 (Part 5) - Floor Modifications DIY: • Intex Excursion 5 (Par...
Негізгі бет Intex Excursion5 (Part 1) - Launch Dolly
Пікірлер: 1