Would it be wrong to just walk around it? All that cutting took so much work.
@filipineaux
2 жыл бұрын
I was thinking the same.
@deletdis6173
2 жыл бұрын
I can smell a whoosh around the corner lmfao
@WoodCutr1
2 жыл бұрын
r/wooosh
@royrogers3624
2 жыл бұрын
@@WoodCutr1 please tell me the joki g going over your head its is the joke and that you actually understood the joke
@webbgroup
2 жыл бұрын
So now I know whose been breaking into my garage now.
@FLFRTrainingBureau
5 жыл бұрын
Thank you for sharing brothers. I like the prop and the way you numbered the cuts. Well done.
@treesplease4053
2 жыл бұрын
Such a noble profession❤❤
@zcharged8294
2 жыл бұрын
why I was recommended this video, I dont think I will ever know 🤷♂
@joshreeves9673
2 жыл бұрын
Great practice and training. Backdrafts are dangerous and when cut properly, can minimize the backdraft. .
@YHK_YT
2 жыл бұрын
Just make a door add some hinges get a doornob maybe add some glass or considering disabling collisions
@mikefargo4339
2 жыл бұрын
#1 make your lateral head cut #2 start your downside cuts left & right (6" below) the first cut #3 tie the two cuts together with a 45 degree diagonal cut.... the panel will then fall inwards. This can be accomplished in under 45 seconds.
@notablediscomfort
2 жыл бұрын
probably don't want the panel to fall inwards and be just another piece of debris inside the structure to watch out for
@mikefargo4339
2 жыл бұрын
@@notablediscomfort Allowing the panel to fall inwards has 2 benefits.... speeds up the entry process, provides chafing protection for advancing inter hoselines that are not drug over jaggedly cut structural framework. It can always be removed at a more advantageous opportunity.
@baconbooger4256
2 жыл бұрын
That’s how I understood the process as well
@larryhoerner2107
2 жыл бұрын
3 cuts instead of 2 for the dame size hole.
@notablediscomfort
2 жыл бұрын
@@mikefargo4339 Well in that case may as well just cut two big swipes on the sides and one at the top and push it in so the panel is still attached at the bottom.
@timrobinson6573
2 жыл бұрын
I would of just bought a new garage remote.
@kyleperalta1824
2 жыл бұрын
👏
@BustedKneeAdventures
2 жыл бұрын
Inverted "v" cut would be better imho.
@trevordeushane5439
3 жыл бұрын
Doesn’t that defeat the purpose of the cut when you rip it off?
@aventador82
2 жыл бұрын
I think the purpose of this exact technique is not to make a perfectly shaped entry point but to make the cutting itself safe for you and your colleagues, but I might be wrong
@NRS375
2 жыл бұрын
@@aventador82 I could be wrong, but im guessing they're talking about how they ripped the door completely off at then end. If the door still remained attached, they could use it as a means to control the flow path still.
Пікірлер: 30