Thank you for this tutorial, i was trying the same thing for the last few days. I watched many videos about this and everyone skipped the cruical step where you have to input the correct input/output addresses in master project. Many thanks and keep up the good work.
@jimmyplc7613
2 жыл бұрын
Thank you for your comment and watching my video :)
@genantamtam9364
Жыл бұрын
@@jimmyplc7613 hi. Is there any difference if i add a PN/PN coupler compared to your way?
@jimmyplc7613
Жыл бұрын
@@genantamtam9364 PN/PN Coupler can be used in the different network between two PLCs. in this case, two PLCs are connected in same network.
@genantamtam9364
Жыл бұрын
@Jimmy PLC ok. Do i have to use IO device when pnpn coupler, or are there other ways? Because i think IO device way is having some limitations? If im not misstaken, you can send/receive only limited amounts of bytes?
@jimmyplc7613
Жыл бұрын
@@genantamtam9364 I think, pnpn coupler with IO device is good solution. And, IO device spend physical I/O address area.
@genantamtam9364
Жыл бұрын
Nice but music is too loud my friend
@mmmyke1784
5 ай бұрын
Thanks mate, saved me with this!
@luckysmart5909
2 жыл бұрын
Awesome, thanks.
@LuisMedina040199
5 ай бұрын
Great!!!
@user-is4qu9re3l
Жыл бұрын
Mr. Jimmy is this possible to communicate between S7-1200 and S7-200 smart master slave setup help of (S7-200 Smart GSD file) Not using get put Instruction block 🛑 ☺️
Пікірлер: 14