There is another felt filter in class tube. I soak it to acetone and usually get job done pretty well. By the way nice video . :)
@tookitogo
2 жыл бұрын
To remove hot melt glue with zero force, flood the joint with isopropyl alcohol. It doesn’t dissolve the glue in any way, but the joint completely releases.
@piecetoyou8285
Жыл бұрын
I own a PACE MBT PPS 85E and that air outlet dial you turn and nothing is happening, On mine there are 3 or 4 holes on the dial. and as you turn the dial from 1 -4 it exposes more air to escape, and in turn less air blowing out at the end of the hot air iron, A bit like a carpet vacuum tube` the slot on a tube you open it and it causes less suction on the carpet , you close the slotted bit on the tube and the suction is greater, but on a carpet vacuum its reverse from the way on the soldering station, Great job on the repair, when sucking up the solder , might need the solder station set higher as solder does not like to remelt unless adding fresh solder to it,so this is why may need to set higher temp. I am new to soldering, if the solder struggling to suck up check tubes are not semi blocked , Did you figure out the suction ?
Пікірлер: 3