What if you want to have nothing in between the two strips. Can you just solder wire in between them to make the connection? Will this cause any issues?
@LEDlightsDMXcontrols_sirs-e
8 жыл бұрын
Hello Blake, Of course. You can solder wires between two segments to expand the length between them, without any issues. Although, if you plan doing this with waterproof strips, you will need to "re-seal" each wire connection using our endcaps and sealant silicone. Feel free to visit our store and this link for more info: sirs-e.com/product-category/led-lighting/led-accessories-led-fixtures-led-lighting/
@LEDlightsDMXcontrols_sirs-e
8 жыл бұрын
You can solder wire in between to make the connection, the only thing you will need to look out for is voltage drop, depending on the voltage of your LED strips. Please check out our 12V and 24V models here, www.sirs-e.com
@techdetech
8 жыл бұрын
nice video, well explained
@LEDlightsDMXcontrols_sirs-e
8 жыл бұрын
+techdetech Thanks for watching.
@ballance1032
8 жыл бұрын
The red doesn't work at all would this help at all?
@LEDlightsDMXcontrols_sirs-e
8 жыл бұрын
Im sorry but I don't quite understand your question.
@djnemesis82pluss1877
6 жыл бұрын
Any idea why some of these led kits have 3 wires and some have 4 ?
@LEDlightsDMXcontrols_sirs-e
6 жыл бұрын
Hello, this all comes down to the type of LED tape that they are and the need for power and signal so it varies.
@blakebauer2722
8 жыл бұрын
Thank you, so with the 4 contacts, do I need a single designated wire for each of the 4 leads or can I use one wire spliced between them all? Will this application be acceptable for accent lighting on a motorcycle?
@LEDlightsDMXcontrols_sirs-e
8 жыл бұрын
as long as each contact is independently connecting each other you should be fine
@thecarolinaboss5934
8 жыл бұрын
before the heat shrink would it be ok to use silicone then the heatshrink??
@LEDlightsDMXcontrols_sirs-e
8 жыл бұрын
Hello Gary, you can use the silicon then the heatshrink, that will be ok.
@andreamitchell4758
8 жыл бұрын
can you do this with philips HUE strips? and is there a quick connector like a clip that you can clamp down on the strip so you do not have to solder? i want to extend a strip, for under cabinets , but there are a breaks for appliances ,and i want to use the same controller
@LEDlightsDMXcontrols_sirs-e
8 жыл бұрын
We do not carry that product so unfortunately I do not know. However we do have couplers for are strips. sirs-e.com/product-category/led-accessories/
Пікірлер: 15