The technique used is referred to as a "clean pull".
The balls in the array are "split", leaving a perfectly even grid to place new ic onto. This eliminates the need for an iron, or any further pad preparation.
The old 1610A1 Tristar is replaced with a newer, less failure prone 1610A3.
This IC fails due to use of aftermarket accessories, such as non MFI certified cables, cheap service station car chargers, and wall chargers that produce a high Peak-to-Peak (P-P) level of electrical noise (sometimes even audible to your ears!).
The 1610Ax tristar ic is used to identify exactly what accessory is connected, and allocate the correct connections to the 8 pin lightning port accordingly.
Failure of this part can lead to messages such as "This Accessory may not be supported", "Not Charging", or sudden death.
It's also a common cause of Blue/Red screen of death boot loops (BSOD/RSOD) and restore errors such as errors 9, 4005, 4013, 4014.
The device in this video no longer turned on at all, had no signs of life, and did not draw any current when connected to a charger.
Contact us today for a quote! We offer an Australian Wide Mail-in service for all consumers and technicians.
Kiosk 6, Market Square Shopping Centre Malop Street, Geelong VIC, 3220
aonemobiles.com.au
repairs@aonemobiles.com.au
Find a technician near you -- boardrepair.info
Негізгі бет Ғылым және технология iPad Air 2 A1566 Tristar Replacement (U3500) No Charging Repair Aus
Пікірлер: 6