#photography #Hasbro
Customizing the Infinity Saga Iron Monger from Hasbro. This is an awesome hunk of plastic. Lends it self well for paint and custom lights I purchased on Amazon from Briksmax.
2- ice blue LEDS
1 White LED
1 Expansion board
1 power wire / usb / battery --- your choice
UV Resin
Step 1
place figure in HOT HOT water - lay the figure flat on its back... the glue in on two spots inside the torso... the edges have little glue. Leave in for 20 minutes, it may require additional time depending on how much glue was used. Pull and slide apart a the wait.. An inner frame will slide out with he head attached.
Step 2
remove the head and other lips from the torso.
Remove the lens from the arch reactor and drill to install the LED
bend a 90 degree to have it lay flat and attach with UV Resin
ONLY IF YOU ARE ADDING LIGHTS.... THIS IS NOT REQUIRED FOR PAINTING.
Step 2
drill the head, remove the inner white plastic and drill behind the eyes, make a cavity to fill with resin and create a lens.
Step 3
set the ice blue LED in place between the eyes and set with UV Resin... then fill with resin. Polish and fill and gaps or cavity left from the resin.
brush Tamiya X-22 for clear coat. Reassemble the head and test the lights
Step 4
attach the expansion board on the inner frame with double stick tape or glue. Attach the head and leads to the board
Step 5
paint the figure using Vallejo gunmetal paint , add washes of color to your liking......Allow 8 hours dry time after sealing your work
Step 5
drill the right arm for the white LED, use a vise drill with a 1/8 bit
now remove the ball joint and drill at an angle in the ball joint cavity.
Cut a slot for the wire to sit and not get pinched, attach the ball joint and test the light
Glue the LED with UV Resin
Step 6
reattach the arm..... heat only the socket not the peg.... repeat for all limbs
CAUTION ... VERY DIFFICULT TO REATTACH THE TORSO
ENJOY YOUR LABOR.......
#actionfigures
Sharing techniques to customize current action figures by painting or sculpting what is needed. Producing a figure the is either improved or just creating one from parts of other figures.
Briksmax / Amazon
LEDs
UV Resin
INSTAGRAM
photobella_photography
FACEBOOK
/ photobella.visual
Not sponsord by any company, all items are purchused by me and and items are created by me. Any links shared are only to share information to other creators.
Негізгі бет IRON MONGER What If Hasbro Marvel legends
Пікірлер: 52