Please if you can do a video how you lift it in the front , that will be so help full
@BloodClut
Жыл бұрын
What brackets do you use to fix the roof rack to the factory holes under the roof trim. They are so hard to find
@Tarasasouthnowna
Жыл бұрын
They are really difficult to find. I have to make them using stainless steel
@liamcosgrave5410
Жыл бұрын
Are you sure the spring isnt the wrong way round ?
@Tarasasouthnowna
Жыл бұрын
Pretty sure i got it right. It does sit right on the axles. I tried flippin' just to double check
@liamcosgrave5410
Жыл бұрын
@Pawikan Navigator ahh okay. I have been doing some research as I am about to install my lift and I'm fairly sure that the tight coils are supposed to be the top ? I could be wrong though
@Tarasasouthnowna
Жыл бұрын
@@liamcosgrave5410 you'll figure it out once the coils are on the axle seat😊
@MegaDirtyberty
Жыл бұрын
@@liamcosgrave5410 You are correct, the "tight" coils are supposed to be at the top.
@christopherpeterson1400
Жыл бұрын
Where did you get the springs & P/N ?
@Tarasasouthnowna
Жыл бұрын
I bought it online in Australia
@allesmunzen2899
9 ай бұрын
@@Tarasasouthnowna can you give me a link or full name of this springs
@yotaowner
5 ай бұрын
U can use the front stock springs from land cruiser 80
@0550rigo
Жыл бұрын
How do you lift it in the front of the car ?????
@Tarasasouthnowna
Жыл бұрын
Easy. Measure the current height front centre of the hub to the edge of fender, jack up the front and let the front wheel suspend in the air. Spray some wd40 or crc to the torsion bolt(spray it hours before you wind it). Then let it down and remeasure until you get your desired height
@Wilt8v92
11 ай бұрын
I can get those springs in about 30min ,no spring compressors,it's a piece of piss...
Пікірлер: 15