On my machines, Elegoo Neptune 3 (your guide), a pad 7 is connected via USB. A Sovol Sv05 it is connected to a pad 7, and each printer has a pad7. IMHO, use whatever works.
@TheFeralEngineer
5 ай бұрын
You get a pad7 and you get a pad7 and YOU GET A PAD7!!!! I love that I can run multiple machines from one pad7, but I still hate the USB sticking out of them. I'm half tempted to run pi devices on each machine then wirelessly control all of them from the pad. I'm sure you can install 20 instances of klipper if all it's doing is air traffic control 😀
@geauxracerx
5 ай бұрын
Also headless on all my machines. If I need to control while at a printer I just use my iPad Pro and browser into Mainsail. I also avoid KlipperScreen as without it I can VCN into the host and do things like quickly make a complete physical backup of the main drive. Found this useful because SD cards are notorious for power cycle induced failure. Having a physical backup has proven several times to be a life saver for me. Will the X3 not work over USB connected to the host/RPi?
Пікірлер: 5