Thank You very much for uploading, didn’t think to use a hole cutter.
@rogerkirby6586
Жыл бұрын
Just bought my second-hand Jaguar from a main dealer having black wheels, decided to get silver, undoing the wheel nuts which were extremely tight, one snapped off. Took the car to a couple of local garages who said they would have to weld on something to get the nut off. this would of destroyed the black wheel for resale. Then I saw this video, tried it and it worked and the black wheels are not touched, Thank you for sharing it saved my day. All garages said main dealership over tighten wheel nuts. Please don't
@lrnick1462
Жыл бұрын
Thanks for this video. You have saved myself and my dad a whole heap of money with just a £5 hole saw. Legend. Thanks very much!
@jamieridealgh5724
Жыл бұрын
That’s exactly what I needed to see…loads of mechanics trying to hammer them off but I kept saying please use a hole cutter. But they won’t so I’ll have to crack on with it myself 🤷🏼♂️ Really appreciate the video, thank you 🙌
@user-kb6ir6tg2n
Жыл бұрын
Just had the same problem. Tried your way and worked a treat, saved me a big bill, took the car to 4 garages and they all scratched their heads.
@bertiepearce123
11 ай бұрын
You absolute genius. Outside the box thinking, turned away by garages but did this myself in 5 mins. Legend
@tech_neos
Жыл бұрын
Bro thank you very much, these garage mechanic was charging me £80 and still unable to remove. I tried your trick and within 5min job done. Please keep sharing your knowledge 🫡
@Nathylad1
10 ай бұрын
Thank you for this! Helped me out big time 👌
@ralphshilling1867
Жыл бұрын
What did you use? You mentioned a 20 mm bit but what kind of bit. Please provide the information of what you used to make this a success.
@colinburrough5621
Жыл бұрын
I have exactly the same query. It looks like the cutter cuts is a counter-clockwise direction but does it have a 1/2 inch drive from the impact wrench? Any information would be appreciated.
@watsonwatson7081
Жыл бұрын
thanks for your video, wheel nut was of in minutes
@colmhudson82
Ай бұрын
What 20mm hole saw you use. Mine lasted 20 seconds and teeth were gone
@corneshalowman8976
4 ай бұрын
What’s the name of the Bit used?
@lukemason2981
Жыл бұрын
20 mm what bit ?
@waynegray4057
Жыл бұрын
Thanks bro, I bold snap on each of my wjeel this morning and the others can't crack, I will not have a try with this
@waynegray4057
Жыл бұрын
Where is part 2? How do you get off the bits left on the studs without damaging the thread
Пікірлер: 17