Nice, maybe you can add one on the wall opening itself, opposite direction so they meet up and close that gap!
@michaelbutler9130
11 күн бұрын
Same problem I got thanks
@J96SIMMONS
Жыл бұрын
Your garage door header must be bowed out in the middle because the sides fit perfectly.
@NYTROeast
Жыл бұрын
Won't the tips of the screw scratch up the finish on the door curtain when to roll up into itself
@AidanSkoyles
Жыл бұрын
yes, this doesn't seem like a very good repair. These doors are not meant to be airtight.
@ryanytc4637
7 ай бұрын
The brackets clamped to the the door center bar and bolted to the top of the 90 degree brackets, which are attached to the front wall, can be adjusted horizontally. Looks like the whole roll needs to be adjusted towards the front wall a bit to seal all the way across.
@edwardupton3082
Жыл бұрын
Maybe scab a board, I.e 1x4, 2x 4 or 6 on bottom of header and adjust to the draft flap? I ordered Agra leaf sweeper brushes to experiment with draft stop. Will see? Thank you for your video.
@sampletaster5093
4 ай бұрын
It helps makes me want to find an alternative.
@salttrash2035
9 ай бұрын
I see the trac rite kit screws to the outside bottom of the header, maybe reinstall this one there?
@cheechortez9174
3 ай бұрын
I hung rug over mine and tied it to the ceiling.
@shayalkobi83
Жыл бұрын
HI, I have a customer that installed a 2500 janus on his garage. he got a lot of water inside, mainly through the rib, does anyone know how we can help him seal it better?
@AidanSkoyles
Жыл бұрын
probably the best bet is to take down the door and board up the opening. these doors aren't going to keep water out.
@hartzland7658
10 ай бұрын
Got to be a better way!
@boompowzap
10 ай бұрын
Let me know if you find it. This does work, though.
@Kgoutdoor
Жыл бұрын
Is this the one on their website that is $4 a foot or $6? There are two different ones.
Пікірлер: 17