great work!! its nice to have the old lines to copy... i have done this on other cars using bailing wire to "prefab" my line routing then come back table side and bend my tubing..... i enjoyed this video good work!
@donalddenning2383
4 жыл бұрын
Nice to see the detail with body off.
@FunFun-tv7gq
4 жыл бұрын
Thanks a lot from Melbourne, Australia 👍
@johnfreeman1189
4 жыл бұрын
Thanks for the excellent info. It looks like that should apply for my 74 super beetle.
@harveytoro7919
2 жыл бұрын
Tremendo video
@MrVostok11
4 жыл бұрын
Nice!
@uabscott1
2 жыл бұрын
It’s appears to be easy with the body off, but how about tips on replacement of the main line from master cyl to rear tee fitting without body removed. There just isn’t much space to get the that flare nut at the tee. It’s a real pain. I guess I need to cut the line to get a 11mm box end on it and work w/ that small space to get it out. Any tips greatly appreciated
@Sam_Mebane
2 жыл бұрын
That is NOT an easy one. The one time I did it on an IRS car with the body on was about 25 years ago, in the dark, under a wet car. My line went bad as I was driving down hill during a rain storm. I got the line roughly run through the car, then threaded it at the rear T before working forward.
@DanMagers-lj7mq
2 ай бұрын
I’m about to attempt the rear brake line with the body on. It’s not looking like fun at the tee.
@Sam_Mebane
2 ай бұрын
@@DanMagers-lj7mq It isn't fun but it is possible. Been there, done that!
@reedrobertson5839
9 ай бұрын
know of a good source for the braided brake line? do they make custom lengths?
@Sam_Mebane
9 ай бұрын
Crown Performance (Vista, CA) is who we go to for custom lines.
@reedrobertson5839
9 ай бұрын
thanks so much!@@Sam_Mebane
@Sam_Mebane
9 ай бұрын
@@reedrobertson5839 no problem at all!
@robertlambert5299
8 ай бұрын
Where can I buy a tubing bender LIKE the one used in the vid?
@Sam_Mebane
8 ай бұрын
It's a "Performance Tool W704C", you should be able to pick one up for less than $10 at most auto parts stores.
@robertlambert5299
8 ай бұрын
@@Sam_Mebane thanks for the info.
@joshcosta423
4 жыл бұрын
Now show everyone how to properly bleed their brakes
@Sam_Mebane
4 жыл бұрын
We just wrapped that one up on this car with some quick bleeders. We do have some older videos that cover it with standard bleeders though. kzitem.info/news/bejne/z5WhqWZ7joCelJg kzitem.info/news/bejne/0qppvYWjr2qEi2U kzitem.info/news/bejne/ypWCtWWZb5h_oJg
Пікірлер: 19