FYI, the relays you used is redundant. As the fuse panel for the switch has relays for each input.
@BasoholMedia
2 жыл бұрын
nice, i went with the 6 switch, and used a grab bar phone mount to hold it.
@officialWWM
2 жыл бұрын
Looks identical to the Auxbeam one.
@JimCantu
2 жыл бұрын
I just got the Auxbeam 8 Gang Switch Panel and it does look to be identical to include the mounting brackets and even the box that it comes in. Hope the Auxbeam works because I could’ve saved some money getting this one!
@MeetTheSLAYER
2 жыл бұрын
That is because auxbeam outsourced it and it was rebranded multiple times. Some have an issue with clearance for the button on the breaker.
@ottoninos5073
2 жыл бұрын
a question those two small cables, one is white and the other red, where did they connect it?
@markg3305
Жыл бұрын
Using outside relays for this is actually a negative. The circuit board itself has solid state relays so you can straight wire all accessories straight to the panel.
@dab0yhdizzle
10 ай бұрын
Nice video quick question I have many lights on my jeep as bar light pods rock lights and whips I Have each Is separate switch each has wiring harness kit I'm wondering that's kill the battery or do I need swtich panel? Thank u
@markvirgona1752
3 жыл бұрын
I just installed this unit in my JT but tried using a fuse tap on cig lighter to power panel in cabin it works but as soon as I close hood it cuts the power to panel
@MohawkDaveOffRoad
3 жыл бұрын
Check your wiring with a volt meter.
@KTMcaptain
2 жыл бұрын
I used an add a circuit to the heated seat fuse.
@overland_explorations
Жыл бұрын
I like where you mounted the switch panel. What screws did you use to mount it there, and is it a strong hold? If you used bolt and nut, how did you gain access to secure them?
@MohawkDaveOffRoad
Жыл бұрын
Thanks! I used a 3M strip and self tapping plastic screws. I wiped the spot with isopropyl alcohol to make sure the double sided 3M strip sticks well and then I drilled small pilot holes for the screws. It does not move.
@overland_explorations
Жыл бұрын
Thanks!!
@JEEPIMPACT
3 жыл бұрын
Is this still working well?
@MohawkDaveOffRoad
3 жыл бұрын
Still works perfect on the Can-am and the Jeep.
@JEEPIMPACT
3 жыл бұрын
@@MohawkDaveOffRoad I ended up going with Voswitch for the direct mount. Now I'm just trying to come up with enough stuff to use all the switches. Great video thanks!
@Richardwhite-h2c
Жыл бұрын
So the back lights stay on all the time?
@losdeapie9499
5 ай бұрын
Same question here
@jasonstorie8740
Жыл бұрын
Are you able to run a winch on this system
@MohawkDaveOffRoad
Жыл бұрын
Yes. You can
@timbutts809
3 жыл бұрын
How long is the data cable ? I want to mount the switches to a CB bar at the top center of the windshield, of my Jt, It roughly measures 7 ft.
Пікірлер: 23