I can’t believe I watched this entire video only to realize he talks about his check engine light sensor a lot but never shows how to clean or what to use to clean the body throttle sensor. I think the video is a good start but goes into way too much detail on starting the engine or not and what he could do but won’t do but never cleans the actual peace.
@RBTheMechanic
2 жыл бұрын
Yeah sorry I will redo this again on another Jeep things didn’t go well that day
@shinobi_homie
2 ай бұрын
UPDATE: REPLACED CRANK POSITION SENSOR, ALL ISSUES FIXED, CHECK ENGINE LIGHT HAS DISAPPEARD. ITS A $30 PART. GOOD LUCK GENTS.
@frankwhite555
3 жыл бұрын
2004 Honda Accord LX 4 cylinder..... So I had my mechanic change out the wiper relay and the fuses but my wipers still don't work. He said it wasn't letting him get any ground when he was using the fuse tester. It wasn't letting him get any ground on certain parts of the wires that you put into the motor if you get what I mean. So I was just wondering what else could it possibly be? He's a great mechanic but I know some others probably know different tricks so I like to get multiple opinions. And it is a new motor. Could the motor be defective? There is also a small hole on the motor but not sure if that's an issue as well.
@RBTheMechanic
3 жыл бұрын
U have to do test on the wiring with test light it can be bad switch u have to test if power is getting to motor It is possable defective motor but u can just put on test light to see if power ground is at motor also. When u put motor on the relay will click so if ur relay clicks that also eliminates possibility that switch is faulty. Anyways if u send me reminder message I can quickest maybe a small diagram video
@RichardLopez-b9y
26 күн бұрын
um you said you were going to tell us what to use to clean it
@RBTheMechanic
26 күн бұрын
Throttle cleaner
@jrverde218
Жыл бұрын
My ‘13 wrangler randomly dies like maybe 4 times since last August. When it dies the etc light comes on and the thing will crank but not fire. But suddenly it fires right up and acts like nothing happened. It’s only happened while maintaining speed twice at 30 and twice at 75ish the thing only has 75k on it and looks immaculate. Has anyone come across such a thing and is there a solution? I’m sick of reading forums that lead nowhere 😢
@RBTheMechanic
Жыл бұрын
Do I have any codes memory or pending codes
@jrverde218
Жыл бұрын
No I tacked the code down and replaced sensor I’m going to go through all the pcm ECM connections to make sure everything is ok
@colbyjackson1270
Жыл бұрын
We have the exact same problem and no clue what it could be.
@RBTheMechanic
Жыл бұрын
@@colbyjackson1270 did u try cleaning the throttle?
@TheBjpenn
7 ай бұрын
Had the same issue, dealership couldn't figure it out. It turned out to be the crankshaft position sensor needed to be replaced.
@alanchanthavisouk8557
3 жыл бұрын
Ac on. When in reverse, car shake hard.. any idea where I can start lookin?
@RBTheMechanic
3 жыл бұрын
Do u have check engine light on? If it’s on scan it and let me know what code you get. Sounds like misfire but let’s see what codes if any
@alanchanthavisouk8557
3 жыл бұрын
@@RBTheMechanic no code. Replaced front main seal. After that ac for driverside dont blow cold. Smh. Dealing with 2016 acura ilx, 60k miles.
@RBTheMechanic
3 жыл бұрын
@@alanchanthavisouk8557 ru able to make video of the shake
@alanchanthavisouk8557
3 жыл бұрын
@@RBTheMechanic no I can't. Feels uncomfortable 😕. And feel like it going to die. Ac compressor checks out , fuse checks out,I'm thinking of just disconnecting the battery and replacing the spark plug.and see where it goes from there. Lol
@RBTheMechanic
3 жыл бұрын
@@alanchanthavisouk8557 it can be misfire and no codes I have come across those lot change the spark plugs and see if there’s any oil in the spark plugs that can cause misfire also if still has issue then u need to connect scantool to check misfire data
Пікірлер: 27