My ancient Jenn-Air (tagged Maytag) oven (model SCE30600B) suffered its second bout of "dim front panel" in a dozen or so years. This is a different model and control board from what is shown in this video but the solution is similar.
@HRTsAFyre
5 жыл бұрын
Great video! If I contact Digitkey eith the panasonic part numbers on my board would they be able to get me the correct replacement parts? My microwave wa a built in 1984 I doubt they sell them under the old part numbers. This is truly a repair video, not a replace video. I dont want to replace an otherwise functioning board. You rock.
@tombutler4533
4 жыл бұрын
Thank you so very much for this video, I already replaced the full control board about 11 years ago $$$. now Ill do this.
@maestromonk6182
3 жыл бұрын
was it only the clock/display or was the entire module dead?
@goingshort
4 жыл бұрын
Can I adjust the brightness of a clock etc or do I need to replace it? You can barely see it during the day.It's a Whirpool Microwave hood oven.
@rymancm
4 жыл бұрын
How did you determine which relay to replace? I have a slightly different model and have already replaced the capacitors and it did not fix problem. I can replace a relay but I have no idea how to figure out which one. Any suggestions would be appreciated.
@snp_u_dwn954
4 жыл бұрын
Do you know the retail price for the range this board goes to? Thanks
@atoz9434
5 жыл бұрын
Good video, From where did you buy the components ? thanks
@robdunlop5718
4 жыл бұрын
Any suggestions on the same problem but for a Jenn Air JJW8530ACB electronic clock control board? (ie which parts would be the problem on this board).
Пікірлер: 13