Wish I would seen this before my jetski took a rock to the hull at 50mph and sank
@connorjones536
6 жыл бұрын
the foamy thing in there is for floatation if the jet ski takes on water
@Stinkyonion17
3 жыл бұрын
Typically need an epoxy fiberglass resin. That bondo resin is not going to stick to most pwcs, dont know about that old one.
@Hugo-Hernandez
4 жыл бұрын
Hey man question when you put the fiberglass pieces on the inside I notice you put a card on one of them. But what did you use to hold the other two pieces in place ??
@isabellagerrard6092
5 жыл бұрын
forgot to clean with acetone to remove the mold release agents
@connorwhitaker8068
2 жыл бұрын
What do I use to clean the fiberglass inbetween coats? Won’t acetone ruin the resin I’m laying down?
@1SageP1
7 жыл бұрын
Ok how did u get it from a crack to a nice hole
@DIYCustoms
7 жыл бұрын
I used a drill with a ceramic wheel cut attachment. This may not be the "safes" but if you take proper precautions, you should be able to cut defective fiberglass with no problems. The hull is not thick of fiberglass material. It's the type of fiberglass sheet which gives it its strength
@connorwhitaker8068
2 жыл бұрын
What fiberglass kit did you buy?
@DIYCustoms
2 жыл бұрын
I used Bondo’s fiberglass cloth #2 with a Resin I picked up at Home Depot. Worked great.
@connorwhitaker8068
2 жыл бұрын
@@DIYCustoms think I’d be fine using autozone kit? They have cloth#2 and resin with the scrapper, also bought the sand paper and a block all I need now is body filler
@DIYCustoms
2 жыл бұрын
@@connorwhitaker8068 That autozone kit should work. Also, don't use regular body fillers meant for steel, use marine body fillers. I bought this one from Amazon and used it for my project. amzn.to/3tzzItc
@connorwhitaker8068
2 жыл бұрын
@@DIYCustoms what happens if I just use fiberglass filler? I can’t get actual marine bondo
@DIYCustoms
2 жыл бұрын
@@connorwhitaker8068 the purpose for the filler is to fill in the imperfections while keeping the repair water proof. Without the filler, you’ll spend a little more time fiberglassing and sanding. After the fiberglass then you’ll add the gel coat, which is also water proof.
Пікірлер: 17