In this video I show you how I made a jewelry box for Valentine's Day. It all started with a piece of wood that I discovered a few months ago when I re-sawed a piece of walnut. When I bookmatched the pieces, it resembled the face of an owl. It was destined to be a really nice top for a jewelry box.
If you run into difficulty with the brass screws and shear off a head like I did, you can use a screw extractor like this one that is designed for very small screws. amzn.to/2jNl2Ak
You can watch my video on how to extract a broken screw here: • How to remove a small ...
Some of the things I used in this build include:
INCRA I-BOX Jig: amzn.to/2LiINyG
Freud SD508 Super Dado Set: amzn.to/2ICoyhJ
INCRA 1000SE Miter Gauge: amzn.to/2rYRR3G
Titebond III wood glue: amzn.to/2IV6MFM
SuperMax Drum Sander: amzn.to/2IV3xOL
Magswitch Featherboard: amzn.to/2Lk34nv
Freud 1/4" spiral upcut router bit: amzn.to/2s18ko1
Freud 1/4" roundover bit: amzn.to/2s043QM
Brusso small box hinges: amzn.to/2x0WCPl
Zinsser SealCoat dewaxed shellac: amzn.to/2kh8qDE
Minwax aerosol lacquer (satin): amzn.to/2IAyzMt
Gimlet set: amzn.to/40DaFEn
90 degree clamping squares: amzn.to/2BbxvLI
Thank you for subscribing to my channel! www.youtube.com...
And be sure to check out my website at www.woodumakeit... !
email: woodumakeit@gmail.com
Instagram: / woodumakeit
Facebook: / reallywoodumakeit
Twitter: / woodumakeit
Pinterest: / woodumakeit
Негізгі бет Jewelry Box for Valentine's Day
Пікірлер: 274