Have the same thing on 800 watts slaps soooooo hard it’s crazy
@billfrigo7602
Жыл бұрын
How are you liking this combo? Do you have enough headroom/power for that sub?
@jkapusty
Жыл бұрын
switched to 12W3V3-2 in a Cp112 box from JL audio and a slash 500/1v1 amp sounds way better.
@billfrigo7602
Жыл бұрын
@@jkapusty - I wonder if that’s the box design or the amp change that makes the bigger difference. I want to keep all the trunk space I can.
@jkapusty
Жыл бұрын
Check my other video. The box makes the difference as well. Amp of course
@milesbachelor8747
Жыл бұрын
@@jkapusty Does your new 12 have a sealed box or a ported? And how wide is it? All my searches circle back to the 12W3 or the 10W3. Wanna run a pair ported but need to know the approx width
@Mad21X
Жыл бұрын
@@milesbachelor8747 Hey I just came across your comments and I would like to make a suggestion to you. You should look into the 10TW3 or the 12TW3 line of subs. They require a lot less vol. and according to JL themselves, they outperform the equivalent full size W3 woofer line. Compare the TW3 vs W3 parameters.
@luikinhunglui430
7 ай бұрын
Where did you buy the box
@jkapusty
7 ай бұрын
atrendusa.com you have plenty of options there specifically designed for the subwoofers you have
@Cheeseypoofs85
Жыл бұрын
it almost sounds like its clipping. where is the gain at on the amp? i was thinking about getting this combo
@julzflies8077
9 ай бұрын
I’ve been trying for ages to get my dual box to sound right. Got a JL spec box sealed. Separate chambers and it helped. But I just cannot tune it and get it to sound right on either of my systems and off of 2 different 1000/1v2 slash amps I’ve tried. I prefer my single 10w7ae ported @32hz or a JL spec sealed box
@chadowen289
5 ай бұрын
I’ve got the same setup and the rd500 is too much amp
@jkapusty
5 ай бұрын
In this current video I do have rd500/1 on this sub. The amp is a perfect match for this subwoofer as the RMS is 500 watts. Yes the RD most likely putts about around 650 watts but use your clipping indicator and set the input sensitivity correctly.
Пікірлер: 15