This DIY shows the fuel pump replacement on a John Deere 285 Kawasaki FD590V engine. The repair is similar/same for other JD, Kubota, Landlord, and Craftsman models equipped with Kawasaki V-twins engines FD440V, FD590V, FD501V, FD501C, and FD611V. Check the Pinned Comment for below for Timestamps, Part Numbers, Torque Values, and other info:
00:32 Diagnostics: fuel pump is leaking due to a failed
diaphragm
01:10 Info on the fire danger
02:16 Fuel Pump Test Info Slide, from Service Manual
02:20 Begin repair: Disconnect the battery (1/2")
02:42 Remove the hood
04:08 Remove the heat shield (1/2")
04:42 Disconnect two fuel lines at the pump
06:05 Remove two mounting bolts (12mm)
07:26 Info about the insulator and gaskets
- Gaskets: JD part M113687 or Kawasaki 11060-2075
- Insulator: JD part M76130 or Kawasaki 16073-2116
08:49 How to remove the fuel pump push rod
09:42 Fuel pump push rod info (JD M76131 or
Kawasaki 13116-2058)
10:20 How this fuel pump is driven by the camshaft
11:38 Info about the new fuel pump part numbers
and design
- Kawasaki 99916-2164, "kit" w/clamp and hose;
- Kawasaki 49040-2082, pump only;
- JD AM132715
15:49 Info on the gaskets and insulator:
- Gaskets: JD part M113687 or Kawasaki 11060-2075
- Insulator: JD part M76130 or Kawasaki
16:25 Prepare pump for install
16:50 Install new pump, torque is 150 inch-lbs (17 Nm)
17:42 Reconnect two fuel lines
18:58 Route the new vent hose
20:00 Check for fuel leaks
21:57 Re-install the heat shield (1/2")
23:11 Re-install the hood
24:20 What's inside the old fuel pump? Destructive
disassembly of the old pump
29:09 Notes on the oil change
29:21 New fire extinguisher installed for safety
I hope this video was helpful for you. Thanks for watching, and good luck with your repair! : )
Негізгі бет Тәжірибелік нұсқаулар және стиль John Deere 285, 345, LX178, LX188 Leaky Fuel Pump DIY (Kawasaki V-Twin FD590V FD440V FD501V FD611V)
Пікірлер: 26