Why did you skip showing the most important Part? Installation & assembly of the Cam and internal components, Timing etc. 🤨☹
@philliphall5198
Жыл бұрын
Yea it would have been better to show it for sure 😊
@markrummel5478
Жыл бұрын
You really need to get a tri-pod for the camera.
@philliphall5198
Жыл бұрын
Hi teck spray works great to hold gaskets in place, just saying 😊and cleaning rust off shaft really helps taking cover off and on plus no seal damage 😊
@davidjenkins9125
Ай бұрын
would have also helped if he would have removed the key on the shaft.
@Lykin333
Жыл бұрын
I think the reason you had a difficult time removing /reinstalling the pan was that you left the keyway in the crank. I hope you didn't damage the new crank seal. Thanks for the video, I'm looking to do the same rebuild to mine. Although mine is a 1989 model in a 285 with fuel injection. I suspect I will be converting it to a carb if I find the fuel injection system is shot.
@smallenginegarage
Жыл бұрын
You are correct I forgot to remove the key, crank seal survived though. Thanks for watching
@Readyfreddyize
Жыл бұрын
Great detailed video.
@smallenginegarage
Жыл бұрын
Thank you brother, I appreciate you watching and commenting.
@alanbexten1931
Жыл бұрын
My jd 425 made it 2200 hrs when cam went put steel one back in. Motor looked really good did total rebuild anyway
@smallenginegarage
Жыл бұрын
Your very lucky it lasted that long. Most don't make it to 1000 hours.
@colinkilbride8736
Күн бұрын
@smallenginegarage my crappy plastic cam just went on me, what part number is this and where can I order it? Thanks brother.
@Super00steve
10 ай бұрын
Mine ruined both the upper bearing, and the lower case? I guess thats what it could be. I have a plane bearing for the top, which should help me, and a new bottom part of the case, since it doesn't have a removable bushing/bearing. Love your videos, gave me the gumption to do it myself!
@smallenginegarage
10 ай бұрын
Awesome! Thank you very much
@Super00steve
10 ай бұрын
I do have a question for ya, my oil pressure relief valve spring is in spec, however it has a tiny gap between it and the cover. Shouldn't it have a little preload on it? Otherwise the ball would never be seated?
@cjjenkins840
Жыл бұрын
RTV a little on the gasket
@benkuehnle4071
Жыл бұрын
Great Video!
@philliphall5198
Жыл бұрын
Thank You for information and video
@smallenginegarage
Жыл бұрын
Thank you
@everythinginsearchsearch9393
8 ай бұрын
I have a JD 285 what is a good metal gear replacement?
Пікірлер: 24