Excellent Video! I did my 445 today 1.5 hours from getting tools out, jacking up and tire off to change out and reassemble. Test ran and good to go!
@miraclesmusic
Жыл бұрын
I've been filling up my 455 with hydro fluid for years with this ongoing leak - this is a great vid - I'm on it!!!
@LukeLBluegrass
2 жыл бұрын
I did this repair on mine today. It's one of those things that looks really difficult but it's actually quite doable. A set of Harbor Freight snap ring pliers with the rubber grips removed was perfect to get the snap ring through the larger hole.
@donnanewman456
2 жыл бұрын
Very helpful. Thank you!!!
@miraclesmusic
Жыл бұрын
That part number is wrong according to JD service in Reedsburg - they list CH17653 FOR FOWARD REVERSE SHAFT?
@freddy15538
10 ай бұрын
CH17653 is correct. There are 2 Orings in it. take both out and replace. I have seen that others say you can actually put 3 in.
@christophorfaust2457
9 ай бұрын
So sad that he did this all wrong. There's 3 seals in this transmission. A packing seal ( what he replaced...) and TWO O-rings (which he didn't). sure to leak again!!!
@901math4
3 жыл бұрын
Great video. I will be doing the same repair soon and you saved me a lot of time. Just curious what replacement seat you bought?
@thediygearhead
3 жыл бұрын
The seat was on the machine when purchased, I believe they can be bought on eBay
@benzion786
2 жыл бұрын
how much did you spend in o rings????
@av8or971
Жыл бұрын
oh but how did you get the snap ring out.
@thediygearhead
Жыл бұрын
I was able to get at it with a set of 90 degree snap ring pliers
@ricklowe6652
2 жыл бұрын
I replaced that right side o ring, and used the tractor about half the season, and it started leaking again. Any thoughts?? What I do wrong, if anything.
@thediygearhead
2 жыл бұрын
My dad has had that issue before, now he typically leaves the same o ring in and just puts a new one on top and it seems to work. Definitely not the correct way to fix it but that’s what he has found works when it still leaks, otherwise check the pressure relief valves on the top of the hydraulic pump on the top of the axle and make sure those aren’t leaking.
@ricklowe6652
2 жыл бұрын
Is there another o r>ng or seal behind this one?
@thediygearhead
2 жыл бұрын
To my knowledge there is not another print behind that one, just one
@av8or971
Жыл бұрын
@@thediygearhead there are 2 o rings in that spot
@danpichee7034
Жыл бұрын
@@av8or971 I was told to put 3 o-rings back in to fix the leak.
Пікірлер: 19