🛑🛑 Are you ok blowing without any rear weight installed?
@2464236536
2 жыл бұрын
You need to install a lockout valve to divert all the hydraulic flow from the rock shaft cylinder to the snowblower rotation cylinder. Lockout value directs hydraulic flow from the rock shaft to the blower rotation cylinder. You change open/close the lockout valve depending on what implement your using, mower deck/snowblower. John Deere charges an arm & leg for this value, after market units work as well and cost significantly less. Installation should take no more than 10 minutes.
@mmrbeef
2 жыл бұрын
Yes I do. I finally remember that I needed one a couple hours after I shot the video. I even have one to install and thought about doing it and then didn't think about it again.
@RamMan2016
2 жыл бұрын
@@mmrbeef where did you get the valve? I’m needing to do my x738
@TriDaddy
Ай бұрын
Hey Kyle, I have a X595.. Upgrading to the X758 (2017). safe to assume I can put the PTO from the X595 into the X758 ommiting the sensor? I plan to disable RIO fulltime so I shouldnt' need the sensor... Thanks!
@TriDaddy
Ай бұрын
Will need to purchase the auto connect deck hanger bracket for the draft arms...
@mmrbeef
Ай бұрын
As far as I know I think you are correct. You can just omit the sensor it will just requiring you to engage the RIO unless you disable it.
@jackolson6479
2 жыл бұрын
Over here we have lots of mowing left. Especially leaf cleanup
@machone7580
2 жыл бұрын
Needs a lockout valve if you don't have one. Fun to install those too, BTW. I need to get my X720 converted from mow to snow here soon too. Nice tractor, thanks for the vid!
@mmrbeef
2 жыл бұрын
Yes I do. I finally remember that I needed one a couple hours after I shot the video. I even have one to install and thought about doing it and then didn't think about it again.
@Fireguy1020
2 жыл бұрын
The delay is because you don't have a lockout valve on the rock shaft cylinder.
@mmrbeef
2 жыл бұрын
Yes I do need a lock out valve. I finally remember that I needed one a couple hours after I shot the video. I even have one to install and thought about doing it and then didn't think about it again.
@nicholasbarth114
2 жыл бұрын
@@mmrbeef get the one from auxiliary hydraulics off ebay. 1/4 turn and half the cost. Guy was extremely helpful with an installation question as well. The deere version has a knob and takes several turns.
@wickedcoyote271
2 жыл бұрын
Man, what I wouldn't give for a drive over deck for my x595!!! I keep a few color coded caps for when I pick up a used attachment that doesn't have them.
@OnlyAura
2 жыл бұрын
I just took the mower deck off my x730 2020 model, and I was wondering if I have to put a PTO cover on the PTO shaft underneath the mower
@zacharybrown2289
2 жыл бұрын
Hey just wondering if you put a shut off behind the control valve?
@danielcrafton6676
2 жыл бұрын
That would explain the delay in the shute. He didn't mention closing off the lockout valve so I bet that's it.
@mmrbeef
2 жыл бұрын
No it is not installed and yes I do need to do that. I finally remember that I needed one a couple hours after I shot the video. I even have one to install and thought about doing it and then didn't think about it again.
@zacharybrown2289
2 жыл бұрын
@@mmrbeef ok thanks
@Captndarty
2 жыл бұрын
I have a 738 and I don’t have the deck hanger land when I use the lock out valve the draft bar doesn’t move and stays up. That being said what is the point of adding the deck hanger lock?
@garyshore5858
3 ай бұрын
Just in case the hydraulics soften... you don't want that draft arm getting close to your snow blower PTO shaft. Think of it as insurance.
@jodys.6274
2 жыл бұрын
I just got an x 720. To hook up my 47 blower I know that will need the longer shaft. will the hanger off of my 445 ? I'm assuming not. Yours looks different.
@bigredgreg1
2 жыл бұрын
Good content 👍
@jdtractorman7445
2 жыл бұрын
Are you going to put a cab on the X758? Lot of wide open area there at your place and windy I would imagine.
@mmrbeef
2 жыл бұрын
Not at this time. I have a 4066R with a cab for the terrible weather days.
@mrbubetube
2 жыл бұрын
pray for a blizzard
@mmrbeef
2 жыл бұрын
We get enough of those without asking for one! kzitem.info/news/bejne/kYqGrpNuqWuVYII
@mrbubetube
2 жыл бұрын
@@mmrbeef HA! oh, ok, I didn't know that. the reason I said that is because on youtube I've seen a whole bunch of videos where people bought a brand new snowblower that they got all excited about, and then they didn't get any snow the whole winter hahahahahahaha.
Пікірлер: 28