Tutorial on replacing a wheel speed sensor on a John Deere hydrostatic dozer. This is shown on a 2000 650H model, but I believe it is the same on all H and J models.
Sensor is: AT360573 Most John Deere dealers stock this sensor.
Sensor adjustment: Back the locking nut off and pull the O-ring back against the locking ring. Install the sensor by hand until you feel it contact the tone ring inside the motor. Back the sensor out 1/2 turn, and test the fit of the sensor protector bracket. There are 2 ways the bracket can be installed, choose the one closest to the installed position of the sensor. You may have to back the sensor out a bit more to fit the bracket, you can turn the sensor out a maximum of 1 turn. Install the bracket, then tighten the locking ring into the motor, compressing the O-ring. Do not overtighten, you don't need to kill it!
Негізгі бет John Deere H and J dozer wheel speed sensor replacement: NOT AS HARD AS YOU THOUGHT!! 650H
No video
Пікірлер: 7