great helpful video! I'll re-iterate myself two things mentioned here, 1 shaft clean clean clean where this sits.Another commenter mentioned the bottom seal spring can come off when sliding onto the shaft (and you will now know it). After i got mine together i put it under pressure, bubbles! what the heck. carefully unbolted the cover and slid it up saw the spring under the seal not on it. Removed the cover (all in one with seals) recleaned the shaft, and took two tweezers to work the spring back on, recleaned shaft and bit more grease on seal....success 2nd go round
@kristoffscuba5466
11 ай бұрын
Love the ladders as a stand. Thats genius.
@understandthepeaches1025
9 ай бұрын
I know, right?!
@JewportMenthols
6 ай бұрын
@@understandthepeaches1025 blew my mind, super smart solution appreicate you for sharing.
@thomasburkett6417
4 ай бұрын
Good practice if you are driving seals in verses pressing is to pack the back sides with Vaseline or marine grease. Occasionally the impact will knock the springs out. Good insurance.
@steveleston1848
21 күн бұрын
I like the ladder holder, I think the 2nd seal is backwards I could be wrong. emory cloth will smooth out the impecfections in the shaft.
@sionetualau
2 ай бұрын
Thanks for the great video. Where did you buy your handpump test from or whatever it's called?
@richgosh7793
2 ай бұрын
Any chance you could show a short video on how to remove the lower unit so I can change my water pump I’m having trouble finding the shift rod screw and I just don’t want to mess it up, but I really want to change it before the season. Thanks
@worldwonders5526
Жыл бұрын
Just flip your socket upside down works perfect
@tomjohansen2083
6 ай бұрын
I think you hit your seals to far down in the housing. They should sitt flush to the top not bottom. now they are blocking the bearing flushing hole over the needle bearing.. I would expect lower lifetime because of this.
@iMarek767
Жыл бұрын
Hi, thanks for video, I have exactly the same water pump replacement situation and discovered loose driveshaft seals... I shall order my set of seals today. BTW: Did you finally change the Exhaust Housing to Shift Rod Grommet? If so, do you have any remarks on that change? Or video? Thanks again & take care ;-) M@rek
@understandthepeaches1025
Жыл бұрын
Hi, I luckily haven’t had any more water intrusion since this seal change so I’m leaving the others alone from now. Maybe tackle next time I do the impeller. Good luck with your seal change. Wasn’t too bad. Just go slow and think and be deliberate. You’ll be good!
@iMarek767
Жыл бұрын
@@understandthepeaches1025 Thanks for info, seals ordered - waiting time about 2 weeks ;-(
@southernmarsh4234
8 ай бұрын
How would there be bubbles on the outside with the vacuum test?
@understandthepeaches1025
8 ай бұрын
The pump works both ways. Sucks and blows. I had it set to pump pressure into the gear case.
@barrytravis5955
Жыл бұрын
Do you know if some year models have a single seal instead of the inner and outer?
@understandthepeaches1025
Жыл бұрын
Sorry I don’t know about other years. Mine had both inner and outer.
Пікірлер: 17