To replace a cam roller, get a plastic funnel and cut a section out of the spout where the taper matches the size needed.
@timothyroberton951
3 жыл бұрын
Screw the throttle cable connection out farther on the other side. Or if its a gear type linkage time the gears!
@jaredtownsend1154
3 жыл бұрын
I figured out on mine it was the plastic idle control on the right side of the motor. This is different than the fuel ratio control by the choke. It’s the plastic piece it’s an opaque white plastic piece that catches the nub on the throttle control arm that turn the flywheel. I flipped it over so it doesn’t catch the nub. It opens and closes with no catch. It’s always the small meaningless parts that kill an engine.
@riptide2449
2 жыл бұрын
My plastic cam roller holes is broken. I have another one coming in the mail. Is there a quick fix I can use in the meantime?
@rongarcia6845
6 жыл бұрын
Did you ever find the correct fix? I am having problem with adjustment screw on cam roller hitting carb while in gear at full throttle. I am not sure if this is normal.
@peterkeen9399
6 жыл бұрын
Ron Garcia The cam roller turned out to be missing the outer ring. I ended up fixing it by wrapping duct tape around the roller to make it a larger diameter. Works much better now
@rongarcia6845
6 жыл бұрын
Peter Keen Thanks
@petermoyes8766
5 жыл бұрын
@@peterkeen9399 i need a cam roller for a 76 9.9 rude ..may be you know if i can buy one still, and the split ring that holds it ..newbee trying to solve rev problems lol
Пікірлер: 13