Kato N scale 10-327 Eurostar DCC installation and bolster repair.
I wasn't going to do a video for this install, but on setting the unit up for final testing, I noticed one of the articulated joints was broken. Most of the video explains that.
The first half are just cell phone screen shots I took as I wasn't planning on turning this into a video so you get some silence.
Used in this video for the DCC install: Digitrax DN163K0 decoder, Kato/Digitrax FL12 function light decoder, warm 3.5mm LED's, 560 ohm surface mount resistors, various bits of scrap wire,
Used in this video for the bolster repair: .035 styrene rod, Tamiya liquid plastic cement and various drill bits.
Anywhoo...you never know what you're going to run into!
Need your Eurostar converted to DCC? Need your other Kato models converted to ESU LokSound? Feel free to shoot me an email or message me on Facebook.
kelley@dufordmodelworks.com
facebook.com/dufordmodelworks
I hope you learned something and if not, I hope you were at least entertained. :)
As always, thanks for watching!
Негізгі бет Kato N scale 10-327 Eurostar repair and DCC installation
No video
Пікірлер: 1