Just got one! Excited to use it. Haven’t pulled the head off of my trolling motor yet but that’s soon to come.
@ChristianTouchet1
2 жыл бұрын
How do you contact him to order one? How much are they?
@TahoeYakFisher
2 жыл бұрын
@@ChristianTouchet1 inquiries at tahoeyakfisher@gmail.com
@jamautomotive8334
Жыл бұрын
how much for one of these set ups
@WhatTheH3ll1000
2 жыл бұрын
Look nice 👍
@smokinjoes9383
Жыл бұрын
Would this work with a Minn Kota 55lb thrust trolling motor?? Thx
@charliewalkerfishing8503
2 жыл бұрын
So I like your setup, however, you took the PWM out of the mesh housing that enabled it to get air. You said that it does not overheat. How long did you run it continuously to test this? If you were to make a long run across a lake or a river, then I can see that it could overheat. Have you tried this and if so, at what speed?
@TahoeYakFisher
2 жыл бұрын
I do live/fish Lake Tahoe, primarily and I run the unit full speed for up to an hour straight every time I go out. I have sold approximately 60 units over the last year and have had zero failures in use up to 55lb. motors. In my experience, heat issues are often due to a factor other than the pwm... maybe too small gauge of wire somewhere or a bad connection. There are junk circuit boards out there, the boards I use come from a trusted source.
@jacobswarringim
2 жыл бұрын
Do you have a link for the PWM you use?
@stevehulsey4458
2 жыл бұрын
I have a NPV 55 thrust I see in the description that your pwm is rated only up to 46 thrust what would need to be improved to be compatible with my motor
@TahoeYakFisher
2 жыл бұрын
Hi Steve, thanks for your interest. I have sold a few to people who have 55lb. motors, thus far I have NO reports of failure. I think a few criteria are important. First, using the manufacturer recommended wire gauge, bigger is better, as well as a circuit breaker at the battery, no larger than 50 amp. If you are using the larger motor because of its "weed whacking" abilities, this controller is not appropriate as you will constantly be in the "max amp draw" range. Otherwise, full speed for prolonged periods should be no problem. Finally, I believe I could build one with a Minn Kota Traxxas circuit board, rated for a 55lb. motor but you would lose the fwd/off/reverse switch in lou of a dual direction potentiometer with an "off" detent in the middle. Kill switch, leads and enclosure would remain the same but the last time I priced out the Minn Kota part it added $100 to the price. Ok, hope this answers all of your questions, lmk if I can do more.
@ericcrawbuck4582
9 ай бұрын
Who makes the box? Is it sealed?
@peternohlmans3388
2 жыл бұрын
Hi can you please tell me how you hooked up the,,,,, kill switch ,,,,, for the trolling motor ,,,,please
@TahoeYakFisher
2 жыл бұрын
No, but I can sell you one.
@philwhelan226
Жыл бұрын
I love one . Price and do you shipping to the UK?
@TahoeYakFisher
Жыл бұрын
Sorry mate, not available at the moment.
@craigpresswood267
2 жыл бұрын
Can you contact me with information for everything you put on a wilderness system atak kayak and what I need to do the same thing to mine with pedal steering as well as the raise n lower motor. Thank you in advance
@TahoeYakFisher
2 жыл бұрын
Hi Craig. I have videos outlining the whole build with links in the description of each vid. Please have a look at my channel. I am willing to answer more specific questions if you'd like to shoot me an email.
@TheTroutman85
Жыл бұрын
Where can I order this
@lukasfalk2522
7 күн бұрын
You should do a video on how you make them
@TahoeYakFisher
7 күн бұрын
@lukasfalk2522 secret recipe! Check out Aksmaniyak, he is the authority on the diy options!
@JamesRichardson-wr1me
8 ай бұрын
Are you still making these?
@TahoeYakFisher
8 ай бұрын
Not at the moment, sorry.
@wadespees7283
2 жыл бұрын
How many amp pwm do you use.
@TahoeYakFisher
2 жыл бұрын
50amp continuous 80amp max.
@user-ht2sh1tz7o
5 ай бұрын
Would this work with a Newport 55 ?
@TahoeYakFisher
5 ай бұрын
It might, I sold a few to people who used them with 55lb. motors. I don't recommend it, but I don't sell them anymore, so it only matters if you have found one on the used market.
@user-ht2sh1tz7o
5 ай бұрын
@@TahoeYakFisher is there anybody else out there that makes something similar to what you were making. And would I be better off with the 35 instead of the 55?
@TahoeYakFisher
5 ай бұрын
@user-ht2sh1tz7o actually a 45lb or 46lb if you go NV works really well for kayaks. Old Town uses Minn Kota 45lb motors on all of their motorized offerings! It's light enough to hoist and has enough torque to get a kayak going as fast as it will go... I have two speed controller suggestions. Aksmaniyak is the authority on diy options and FPV is a company that sells a unit very similar to mine through a retail store called Mariner Sails. Hope this helps... what kayak are you outfitting?
@abfernandez5604
Жыл бұрын
Where to buy it?
@TahoeYakFisher
Жыл бұрын
Sorry mate, no longer available.
@lawrencemartineau3406
2 жыл бұрын
Hey, to this how do I get a price for yo to make one for me, I have a Brooklin kayak with peddle drive and plan to put motor in there. and 45# trust trolling motor I would like to put all worrying in hall
@TahoeYakFisher
2 жыл бұрын
Price is in the description.
@jimhorton1039
2 жыл бұрын
Are you selling these ? I would like to inquire about buying
@TahoeYakFisher
2 жыл бұрын
I am, inquiries at tahoeyakfisher@gmail.com
@massholetv5353
Жыл бұрын
Do you not make these anymore?
@TahoeYakFisher
Жыл бұрын
At this time I am having trouble finding quality circuit boards at a reasonable price... I just ordered 10 boards, if they are usable we are in business. Hit me up at tahoeyakfisher@gmail.com
@massholetv5353
Жыл бұрын
@@TahoeYakFisher copy that..
@TahoeYakFisher
Жыл бұрын
@@massholetv5353 check my edited reply, I'm going to try again.
Пікірлер: 42