I noticed that the two white rubber bushes in the large pulley are in very bad condition. It is possible to carefully drill out the rivets (important: save the little tubes which pass through the rubber bushes), scrape off any old rubber, clean up the pulley with detergent and an old toothbrush, and replace the bushes with suitably sized rubber grommets. Remember to put the small tubes back in the centre hole of the new grommets. Then reassemble with new rivets and backing washers behind the clutch plate.
@hani7230
2 жыл бұрын
Thank you so much for your kind comment will surely do this :)
@helifaxnz
2 жыл бұрын
Thank you for your video. This helped me in refurbishing my A701A.
@hani7230
2 жыл бұрын
You're welcome ☺️
@aimanzahra5817
2 жыл бұрын
Thankyou so much this helped me fix my gearbox at home ^_^
@hani7230
2 жыл бұрын
Glad that it helped you :))
@narjisfatima5044
2 жыл бұрын
Please upload more restoration content 🔥❤️ This really helped 🥺❤️
@hani7230
2 жыл бұрын
Sure ❤️ Glad you liked it ❤️
@waleedarif6587
2 жыл бұрын
V informative
@hani7230
2 жыл бұрын
Glad to hear that :)
@hanihaider4107
2 жыл бұрын
Please make a video on how we can change or fix washing machine gear box too 🙂
@hani7230
2 жыл бұрын
Sure I'll :)
@magnusfolke-olsen3762
2 жыл бұрын
My kenwood overheats and turns off sometimes. Does trist help?
@hani7230
2 жыл бұрын
It can happen due to motor issues, most probably it's carbon brushes are finished.
Пікірлер: 14