quick tip,,,Woodruf key is half mooned like that so you can push the end nearest end to you down to form a "ramp",,,,,the key way also has a radius inside so it can level out with the flywheel as it goes on,,,,like a rocking chair bottom or foot working in a slot with the same profile,,,,,,,,,,makes life much easier
@kenudo89
3 жыл бұрын
What will you do if you have the original carburator? And i heard that if you use pre mix the bike will smoke a lot of white smoke
@Radness1001
3 жыл бұрын
You'd blank off the 2 stroke feed on the carb, usually a piece of thin rod into an inch long piece of pipe, drill bit shank will do. Premix smokes less than auto lube as the mixture is closely controlled.
@st3rg
Жыл бұрын
@@Radness1001 what ratio oil to fuel you use?
@Radness1001
Жыл бұрын
@@st3rg 1:32 same as a YZ125/250
@lordx4542
5 ай бұрын
Зачем его отключать? почему вы считаете,что лучше подавать готовую смесь для этого мотора?
@Radness1001
5 ай бұрын
The pumps fail and over oil. And now been discontinued.
@adnaltintas
3 жыл бұрын
Have nice day, if the oil pump is not needed, how did you find a solution instead?
@Radness1001
3 жыл бұрын
Premix the fuel and 2 stroke oil, at a ratio of 1:32. Much better this way.
@adnaltintas
3 жыл бұрын
@@Radness1001 Thanks for sharing. I will also cancel the automatic lubrication of Bws 100. Tired of cleaning oil sludge. 😊
@ruwaynefilmalter7717
Жыл бұрын
Wait what do i do after i pulled the autolube gear off?
@Radness1001
Жыл бұрын
Blank off the oil feed to the carb. Drain the fuel tank and add 1:32 ratio of 2 stoke to petrol.
@lordx4542
5 ай бұрын
@@Radness1001 My 2-stroke engine oil drum says 1:20 mixture ratio. And it may vary depending on the manufacturer of the oil you buy. In my case, this is the French oil "IPONE Samurai". What to do in this situation?
@Radness1001
5 ай бұрын
@@lordx4542 Yamaha recommends 1:32 same as their MX bikes yz125 & 250
Пікірлер