Followed your instructions for my 2009 i30, worked a treat! Thanks!
@FrySVK
2 жыл бұрын
Super video, presne toto ma postihlo s mojou Ceed, ťažké štarty, slabý výkon motora, po výmene snímača ide auto ako nové, úplný iný zážitok z jazdy a aj problémové štartovanie to vyriešilo.
@eliOOO1-
4 ай бұрын
Dobrý deň ,ôže ten snimač mať problem auto vôbec nechce štartovať ?
@FrySVK
4 ай бұрын
Tažko povedat, je to jedna z vecí, ktorá pri štarte sú potreba. Isiel by som minimalne na diagnostiku.
@eliOOO1-
4 ай бұрын
@@FrySVK Daval som ukazalo tento problém potom už vyplo nechce auto natočiť sviečky dal nové čerpadlo počuť nič ide ide ide ale nič z ničoho nič auto šlo ráno šiel už som nemohol natočiť Dakujem za odpoved
@miroskal2593
3 ай бұрын
Super video 👍👍👍
@bobcat2378
2 жыл бұрын
Thanks for the video very helpfull.
@Martin-vy2hr
Жыл бұрын
hezke video, dik
@gernotskupin8472
Жыл бұрын
Vielen Dank für das Video!
@Igor_ZG
Жыл бұрын
Nice video! I only have to figure out, how to come under the car. Can I do it only from above??
@glicerinaldehid
Жыл бұрын
Hello I have a question my car stopped during running on the highway right after I started the Aircon. Could it linked to this sensor? The engine when I want to start is really trying to start up but seems like no gasoline is coming. Could it be this sensor is something related to the fuel pump? Or spark plugs?
@marcusr8017
Жыл бұрын
just replaced mine on a 1.4 2015 kia ceed...car wont start now!....got a PO335 crank sensor pending fault ?...faulty sensor?...not touched anything else
@Amhrepairs
Жыл бұрын
does the engine speed value show during starting in Diagnostic? if nothing is displayed (engine speed is at 0) the problem is somewhere in the wiring or a bad - unsuitable speed sensor. If it shows engine speed during start - the problem is somewhere else, but from my position it is imposible to determine where
@marquesmazucanemacie7303
2 жыл бұрын
Wonderful vídeo, My engine have problem is not start The check engine sinal is not on at pinel. Wat can Ido??
@Amhrepairs
2 жыл бұрын
ideally, it is good to use OBDII diagnostics, and check the engine speed during start-up. When the revolutions show, there is no problem in the crank sensor. It happens that the immo light flashes during starting, that would be a problem in the coil of the ignition switch (video will be coming soon)
Пікірлер: 15