I grease the hell out of the sliding part of the shaft every other use. Pull it most the way out, fill a rag with grease and slop it on.
@ddssdickday
10 ай бұрын
If you'd like to keep the cutter from rusting through completely, keep the top of the deck clean. All of those sticks, leaves and dirt, when wet, will rot the deck out for sure.
@ProtonOne11
10 ай бұрын
PTO driveshafts on our farm are greased up so they don't rust together. Just don't go crazy with it so you don't flick around a lot of grease when you spin them up for the first time. Usually just pull them apart and brush on some new grease when we grease up the joint bearings anyway.
@pauldrulik2410
Жыл бұрын
good videos mate, got to burn those clutches in start of summer after sitting in winter. back off the spring tension bolts and let it spin in the housing by engaging the clutch and disengaging it a few times or as much as needed to burn in and release it if its stuck from sitting with water and rusting up like yours did. then set the tension so it grabs and spins
@deplorable_2024
2 ай бұрын
Use your tractors loader/forklift and chain to lift the mower onto its side. Much easier to takeoff blades and stump jumper. Easier to remove blades before stump jumper.
@darrenmccomic7325
Ай бұрын
You might try some grease on your drive shaft alot of it and try working on a work bench and a vice
@hoopiemade
Ай бұрын
@@darrenmccomic7325 i put grease on when i use it. And useing the vice would make to much sence lol
@picsaregreat
Жыл бұрын
I put grease on my pto shaft. It will only stick if I leave it for extended periods, but not over winter.
@dennisodle1923
3 ай бұрын
Bushhogs get more damage by being left outside in the weather than anything if a person can't put one in a barn or shed get a good tarp keeping the rain off of one will stop alot of the rusting up
@racerzl1
Жыл бұрын
Another good video Hoopie. I enjoyed it.
@joutdoorsmen23
Жыл бұрын
Cool video keep them coming
@James-ru4jx
2 ай бұрын
More work,less commentary = better video.
@cecilchristopher5092
3 ай бұрын
Take your blades off before removing the stump jumper
@hoopiemade
3 ай бұрын
Befor i cut the hole in the deck that was impossible to do.
@kevinalexander668
6 ай бұрын
That's not a king kutter bush hog.
@hoopiemade
6 ай бұрын
Thats what the manual says. And thats what the blades and other parts iv goten are for.
@stevekoonscolretired.usarm6345
4 ай бұрын
@@hoopiemadeBelieve your cutter is an International World Agritech IM 602. I have the same model. Good video! Thanks for posting!
@chrisn7632
2 ай бұрын
My King Kutter has a hole from the factory to access blade nuts so Steve Koon is probably right.
@steveemery2880
2 ай бұрын
@@stevekoonscolretired.usarm6345 I have this model too, you wouldn't happen to have a manual for it?
Пікірлер: 19