@3DPrintsEverything, omg.outstanding -see you soon, ;))
@3DPrintsEverything
Жыл бұрын
See you soon!
@RJin3D
Жыл бұрын
Thanks for the video as always. I'm a big fan of core XY and there aren't a lot of entry level options. I thought you were supposed to heat the bed before leveling though? Or was this just a quick and dirty setup?
@toasterdev8329
Жыл бұрын
this isnt a corexy
@3DPrintsEverything
Жыл бұрын
I dont think you should have to heat bed, its good to heat nozzle just for the sake of plastic at the tip of nozzle making it longer than it should be ect. I would only think heat the bed if the bed warps when heated but thats a whole different issue
@FlyingDropBearAU
Жыл бұрын
Just a note, but that "flip the power supply (220>110)" doesn't work outside 110-ville. If the reverse situation (110 switch on 220 AC) occurs, you let the magic blue smoke out. Otherwise, fantastic vid.
@3DPrintsEverything
Жыл бұрын
Thank you.
@lucaaleotti3212
Жыл бұрын
Hi, I have a question: I orderd a KP3S on Kingroon site, but because the lack of supply the orderd is late so they offered to send me a KP7 instead. It would be my first 3d printer, so I should wait for the KP3S or get the KP7? Thank you!
@3DPrintsEverything
Жыл бұрын
Either is a good printer! The KP7 will be larger so go for it!
Пікірлер: 10