See how easy it is to set up the Kreg Rip Cut on your circular saw. And get tips for making accurate cuts with it.
Details and snapshots here bit.ly/36s3q7h
** Thank you ** for using my affiliate link below to help support the free and helpful info you get on Heartwood Art.
- Kreg Rip Cut from Amazon amzn.to/2TOWkHx
***********
See more!
***********
Visit heartwoodart.com for more builds and tips.
***********************
Follow Heartwood Art
************************
Instagram / heartwoodartcreations
Pinterest / heartwoodart
Facebook / heartwoodartcreations
Video Chapters
00:00 Intro
00:35 Parts of the Kreg Rip Cut System
01:05 Tools needed - Phillips and flat screwdriver
01:30 Check lip of circular saw foot
01:40 Check sled spacer orientation and match to saw foot plate
02:05 3 screws that need to be loosened on Kreg Rip Cut sled
02:15 Saw foot block on Kreg Rip Cut sled
02:45 place circular saw into Kreg Rip Cut sled
02:55 check that saw blade guard is not touching sled
03:40 tighten saw foot block on Kreg Rip Cut sled
04:00 loosen swivels and set screws on Kreg Rip Cut sled
04:20 place set screws on saw foot plate
04:45 tighten set screws until they touch then tighten down swivels
05:55 Set up Kreg Rip Cut guide for left or right hand use
06:25 remove 2 guide screws under tape
06:35 attach Kreg Rip Cut rail to guide
07:00 set rail flat and ensure guide is square
07:30 how Kreg Rip Cut rail attaches to guide
07:55 turn saw on side to get rail started
08:20 move Kreg Rip Cut sled to edge of guide
08:45 ensure blade guard is not binding and can move freely
10:00 align red cursor on Kreg Rip Cut sled to first line on rail
11:30 why not to grab guide handle on Kreg Rip Cut for making thin cuts
Негізгі бет Тәжірибелік нұсқаулар және стиль Kreg Rip Cut Setup and Tips
Пікірлер: 78