I'm using the same tractor/hours and find this the only thing that I still need to deal with. After working for a half hour or so my leg gets sore and feels real tight the next day. Going to start with WD40. Maybe my dealership has some tips or a fix from the factory. Never tried installing a grease fitting.
@justinw4503
Жыл бұрын
It's fairly simple. You could always drill the hole and use drive in. Also another guy mentioned in the comments he removed a different spring and it worked for him.
@chevyjennings3404
Жыл бұрын
Good information. What kind of zerk did you use and what size?
@justinw4503
Жыл бұрын
Thanks. I bought metric assortment kit at local hardware 6mm it has straight ,45, and 90s in it
@chevyjennings3404
Жыл бұрын
@@justinw4503 threaded or drive in? Do you think a guy could drill and drive in a zerk w/o removing the shaft inside. Seems like it is a tight fit.
@justinw4503
Жыл бұрын
It might be possible if you used a bottom tap and a shallow zerk fitting and or put a small washer on the zerk to keep from bottoming out on. I carefully ground mine down they only stick threw tiny bit. But they make real shallow ones that I put in my grapple
@xenomorph7299
3 жыл бұрын
Farts out my ass
@WestHawaiiRealEstate
2 жыл бұрын
Question, did you do anything with the stiff dampener? My b2301 is brand new and stiff, feels more like the dampener, than being dry on grease. Thank you in advance
Пікірлер: 10