Man, please help with this. I am struggling with my 2020 sportster 883. I can they the front cover to fit properly. Also did you install the vacuum adapter?
@thorgeirnable
3 жыл бұрын
I didn't have to install any vacuum adapters. I forget what they are called but the silvery bolts that the tubes connect to are the only things I replaced such as that. Is it the outside cover that isn't going on?
@edgarsanchez9734
3 жыл бұрын
@@thorgeirnable thanks for the reply for starters! And yes I cant get the filter and cover to fit properly.
@thorgeirnable
3 жыл бұрын
@@edgarsanchez9734 make sure that black inner ring in in there correctly and seated all the way down. Then the filter if I'm not mistaken just sits in there, either direction
@edgarsanchez9734
3 жыл бұрын
@@thorgeirnable hey man, so I got the cover on and I have the air hoses attached to the breather bolts. But I’m noticing the metal air intake valves (flaps) aren’t moving when I test the motor for reviving and such any idea if that is ok? Also when I move them by hand I can feel that I am just barely scrapping against the air filter is that normal?
@thorgeirnable
3 жыл бұрын
@@edgarsanchez9734 because this isn't a real supercharger, only a glorified air filter, they won't move much. The scrapings shouldn't affect you because it will in reality never get that far. There is a little adjustment screw on the outside for positioning, but other than that it sounds like you're ready to rip. Good job brother
Пікірлер: 7