I may have watched your entire video except for the fact the Wind and the bad video ended that. I wish people would edit their videos after taking the time to make them!
@جمالعبدالقادر-ح3د
10 ай бұрын
That's awesome
@feelgood2454
9 жыл бұрын
The rung the pulley is attached to at the top will bend easily... it's not strong enough for a heavy load, probably weakened by the hole drilled in it too. It's best to put a square steel bar on the top of the ladder. See my assembly video. I've bent the rung and can tell you that it will warp the ladder or break and the load will fall.
@chuckgilbert2035
Жыл бұрын
I reinforced the rung by sliding a tube down inside it and securing it with a screw.
@stephensadlonsj.2837
2 жыл бұрын
Could you define the making of the carriage? Love your design.Do you sell these?
@tazzthedoodle7861
2 жыл бұрын
That top rung you have the pully on will not be strong enough..... i tried that with a way heavier ladder and it bent and broke off. I do like the way you mounted the winch tho
@twoZJs
9 жыл бұрын
Al, when you were threading the shuttle on to the ladder, your camera is too fuzzy to see the detail of what you have to reduce the friction. Do you have nylon/teflon buttons on the bottom side of the shuttle to ride/slide on the ladder frame? Neat design.
@cecilholt2710
4 жыл бұрын
What do it cost to buy one
@feelgood2454
10 жыл бұрын
I've built about 150 of these. I have a few videos... just look on the right side and you'll see them.
@dennisbarger9287
9 жыл бұрын
where could a man buy one of this i do roofing and i need it
@dennisbarger9287
9 жыл бұрын
how do you sale for
@osmarschling1637
4 жыл бұрын
Parabéns
@lissa4306
2 жыл бұрын
No info or replies from Alvie asking what company he bought this ladder hoist from. Everybody needs a sponsor before they provide info! No point in watching this video!
Пікірлер: 13