Abonniert diesen Kanal um keine weiteren Videos zu verpassen (es ist kostenlos)
@memolidogan
6 ай бұрын
Du bist ein Ehrenmann!
@FatHead1979
Ай бұрын
Very good video, good information and not a lot of 'filler' like a lot of YT videos! 👍
@AutoSchrauber
Ай бұрын
Thank you very much for your kind words. I'm glad to hear that the video was helpful for you
@FatHead1979
Ай бұрын
@@AutoSchrauber You're very welcome. I have this job to complete on my recently purchased 2.2 TDCi (200), so I haven't yet been undernath the car. Could you please confirm if the undertray needs to be removed and how high I need to get the drivers side of the car to allow a reasonable level of access i.e. do you think jacking up the car will be sufficient to allow access?
@AutoSchrauber
Ай бұрын
Yes, the underbody protection has to be removed to get to the lambda sensor. I can't imagine that jacking up the car is enough for this repair. From experience, the lambda sensors are very tightly fitted/have ‘baked on’ over the years. This means that a large spanner (large leverage) will probably be required to loosen them.
@FatHead1979
Ай бұрын
@@AutoSchrauber Thank you for that information, so you think it needs to be done on a lift then i.e. at a proeprly equipped garage?
@AutoSchrauber
Ай бұрын
i would say it should be a lifting platform or a pit. Because if the lambda sensor cannot be released (which happens often). Then you would need a large tool with a long lever, if the car is only jacked up, you cannot use such a tool.
Пікірлер: 9