In this video I show you how you can deactivate build mode (Transport mode) and how you Re-enable EAS using a GAP iidtool BT. This is what you need to do after replacing the air reservoir or have run any of the deflate procedures.
Disclaimer: I'm not a trained mechanic. The air suspension can be dangerous to work on if done wrong due to highly compressed air.
FAULT CODE: C1A00-53 (AF) Control module - System programming failure - deactivated
FAULT CODE: C1A00-53 (AF) Control module - System programming failure - missing calibration
Initial fault code for the reservoir replacement.
FAULT CODE: C1A20-64 (AF) Pressure increases too slow when filling reservoir - Algorithm based failure - signal plausibility failure
If you have any questions feel free to write a comment and I will respond as soon as possible.
Remember to support the channel by subcribing and support it even more by becomming a Land Rover Drive Patreon.
PATREON: / landroverdrive
Affiliate links:
iiDTOOL BT UK-ebay link:
ebay.us/b7uLCO
iiDTOOL BT US-ebay link:
ebay.us/W4sC8W
JETBOIL UK:
ebay.us/6b2Ybp
Edited in Adobe Premier Pro by Simon Schybaj Mastermo - SIMON FILM STUDIO MASTERMO
"This video details contains affiliate links for which I may be compensated for."
Some of the links above are affiliate links, where I earn a small commission if you click on the link and purchase an item. You are not obligated to do so, but it does help fund these videos in hopes of bringing value to you!
For sponsorship, product reviews, and collaboration, you can email me here: contact@landroverdrive.com
ig and fb: @landroverdrive
Негізгі бет Автокөліктер мен көлік құралдары Land Rover Discovery 3 DEACTIVATE BUILD MODE & RE-ENABLE EAS - GAP iiDTool
Пікірлер: 28