I repaired one ! One of the hall was out by 2 mm and cause the controler to stop!
@Lolteba_19
Ай бұрын
you shouldn't have fucked it up! you should take care of the values!!! because these are not cheap things!
@NeilSnapePhotography
Жыл бұрын
If by disconnecting the HAL terminal block and it runs smoothly that would say there is one or more HAL sensors that are not working.
@TomasFuk-ih4of
Ай бұрын
Ahoj z jaké stránky jsi kupoval náhradní díl ? Diki
@vlastimilporuba7209
Ай бұрын
@@TomasFuk-ih4of bangood
@traebrownn
Жыл бұрын
any idea on why my back motor of my laotie ti30 makes a loud rumble and rattle noise when i first take off. only occurs when scooter is on the ground.
@mstrpth287
4 ай бұрын
I have this same issue and can't seem to find a solution
@darius_football893
3 ай бұрын
@@mstrpth287hello did you find the solution?
@mstrpth287
3 ай бұрын
@darius_football893 not yet. People say the hall sensor but I don't think so, I don't believe it's bearing related. My guess is the controller but I have nothing to back that up with.
@darius_football893
3 ай бұрын
@@mstrpth287 Do you know where i can find a front controler and a front motor cuz i dont know what type of controler it needs but i know the motor.If you know a good webstie (globally) where i can find the right controler it would help (sorry for my bad english i am from romania)
@mstrpth287
3 ай бұрын
@@darius_football893 I don't, sorry. I haven't looked into it all that much as the scooter still runs. I think I'm going to switch the front controller with the rear and see if that makes a difference. If so, then I know it's the controller.
@MissHitAllTheTime
9 ай бұрын
were you able to smell the controller for anything burn or front motor??? mines both is not working and i see brownish stuff in both my controller and my rear motor the phase wires melted a bit and also smelling burn smell from both my controllers.
@wyatttingle-key5313
6 ай бұрын
Same
@user-vv3hj1wm5s
7 ай бұрын
I also have this problem the front tire sometimes works and sometimes doesn't
@user-vv3hj1wm5s
7 ай бұрын
I had this problem with my scooter too, I fixed it, if not with your scooter, let me know if your scooter is working too.
@alexorsel832
Жыл бұрын
Mám stejný problém, přední kolo se netočí a zadní jen pomalu a také nereaguje na červený a žlutý přepínač. Zkusil jsem rozdělat controller nefunkčního motoru. Hned po odšroubování bočního krytu bylo vidět opálené místo mezi deskou a hliníkovým obalem. Větší vrstva cínu na plusové cestě se pravděpodobně otřesy při jízdě dotkla obalu a vyskratovala controller.
@vlastimilporuba7209
Жыл бұрын
Ahoj, tak to mame stejne. Mel jsem odpapeny predni kontroller a po vymene za novy je vse ok👍🙂
@alexorsel832
Жыл бұрын
@@vlastimilporuba7209 Také jsem hned objednal nový, za týden byl z Banggoodu doma a zase jezdím.😀
@darius_football893
3 ай бұрын
Hello i got the same problem but i ordered the new front motor and the controler but the reapir shop told me its not the good one.Can someone please help me and show me what motor and controler i should buy.I can talk trough instagram too i just need help repairing it.):
@darius_football893
Жыл бұрын
Hello i got the same problem. If you made it can you Tell me What is the problem?
@veikko-tc1gi
Жыл бұрын
i got the same problem too. but the strange thing is that when i spin the front wheel by hand ,it starts working .
@darius_football893
Жыл бұрын
@@veikko-tc1gi ill try it
@peterryan9951
Жыл бұрын
@@veikko-tc1gi i have the same problem did u fix it
@veikko-tc1gi
Жыл бұрын
@@peterryan9951 not yet. i think ,the best way is to find electrician ,who has tools to measure electric current coming from battery to the motor and find out ,why motor does not work instantly.
@peterryan9951
Жыл бұрын
@@veikko-tc1gi im just after taking my front wheel apart on green wire hall sensor getting no currant i followed it back to a clip from there it is small blue wire to controller still no currant so i think il do more testing to see why .
@user-nw1bm6gm9w
Жыл бұрын
0:57 why mine is 25km
@antoniskrj
Жыл бұрын
Hey did you find solution?
@vlastimilporuba7209
Жыл бұрын
Yes, new front motor and new front controler (controler burn motor...)
@user-vv3hj1wm5s
7 ай бұрын
When I checked the motor with the front controller, it still works. I think the problem is with the controller or the red button. @@vlastimilporuba7209
Пікірлер: 35