I like the idea. It does have its drawbacks (previous comment). I agree with a little care, it should be faster than other methods. And besides, you practiced your skills and made something useful. Where did you find the bell housing? Or did you make that as well?
@JIMMY916
26 күн бұрын
Thank you for your appreciation and your comment. No, it's not my idea. It is a tool that I found in an old book for machinists and long forgotten.
@alterstassfurter5743
5 ай бұрын
But ...if this tool is`nt centered you`ll never found the center...set it into an angel +- and you will fail...
@JIMMY916
5 ай бұрын
With a little care, the errors are tiny and insignificant. No method guarantees finding the perfect center because the metal bars are not perfectly round. They become perfectly round after being turned, but then you don't need the center finder anymore. Thank you for your comment and for your time !
@RicksterX-92fs
5 ай бұрын
There are MUCH easier ways to find “approximate” centers than this! That’s a lot of effort to still rely on eyeballing it.
@JIMMY916
5 ай бұрын
Just because there are other ''easier'' methods, doesn't mean this tool is useless..A small deviation from linearity does not produce dramatic effects in ''approximate'' the center point. In future videos I will also do the other methods of finding the center and we will see which is the best method. Thank you for your comment and for your time !
Пікірлер: 6