I appreciate the detailed demo, since the servo tester did not come with any instructions. I am new to the hobby and have a lot of things to learn. The video was a great help.
@TCSC47
5 жыл бұрын
Just to echo this. I had no idea how to use the thing!
@bigchungus-oj8zz
5 жыл бұрын
Thank you sir. Very much appreciated! I have one, hadn't tried it, no instructions...great demo
@EZbuildRC
6 жыл бұрын
It has 3 modes, In centering mode what it does is send the signal that is right in the center of both ends of signal range. So this is what your radio signal ( pulse width ) should be when your sticks are in the center position. I find it fairly accurate.
@gortnewton4765
5 жыл бұрын
Nice video. I'll get a couple of those. Thanks for showing us.
@EZbuildRC
4 жыл бұрын
Yes you can use it as a manual thrust control.
@JanJeronimus
5 жыл бұрын
Good detailed demo as i no instructions where included with the tester. (If you turn of the beeping this demo would even be better!)
@davidbolha
6 жыл бұрын
Hi, Thank you for your in-depth explanation on this device. However it would have been so much better if you had shown what was connected on all of those 3 x 3-pin connector wires (for visual reference). 🤔 Still gave you the thumbs up. ☺
@davidbolha
6 жыл бұрын
PS: I referenced your video on my video: kzitem.info/news/bejne/poh6u6qZh4qfh20 You pop up @ 02:03 Keep up the good work !
@garyvale8347
2 жыл бұрын
helpful video !!!! I was unsure if I was able to use my 3S 2200 mAh LiPo to test my servos with , because the tester states 4.0v - 6.0v range.....but if I understand correctly , as long as I connect the higher voltage LiPo battery through the ESC, it's OK...correct?....thanks
@diegoandalexcockatiel7540
4 жыл бұрын
CAn i use it as a type of thrust controller? Plz reply!
@NathanielBechard
7 жыл бұрын
you can build one its a circut with a 555 timer ic
@TCSC47
7 жыл бұрын
Sure you can if that is what you want to do. But this little tester device does a few more things than a 555 timer alone. I got mine for about £2, quite a bit cheaper than the price quoted here, by ordering it from a Chinese web site. You couldn't build it for that including pcb, and connectors etc. As lazertoys says this tester allows you to test a lot of your RC setup without tears.
@gortnewton4765
5 жыл бұрын
@@TCSC47 That's good advice. I bought 3 of them for AUD$5.47 on ebay, nice unit and you are right that we couldn't build it for such a small price.
@shaider1982
6 жыл бұрын
Hi there. Will this center all servos or will there be a few variations between? Thanks.
@andersontavares8484
7 жыл бұрын
alguém sabe aquela parte que tem que colocar a energia qual é o nome do cabo
@jameswiser
7 жыл бұрын
beep beep beep beep beep
@atyla62
4 жыл бұрын
Can move 360° thanks
@rossrcfallacaro3422
4 жыл бұрын
I know this is an old video, but I’m trying this now and only get beeps from the motor, no movement. Any ideas? It’s almost as the esc needs to be callibrated first
@zakariakhamees
4 жыл бұрын
I have the same problem.. did you solve it?
@rossrcfallacaro3422
4 жыл бұрын
Zakaria Khamees I have not. I’m gonna do some more research on google and I’ll get back to you by end of day
Пікірлер: 25