Joe, great tutorial. Any reason why the process would be different with your 150 gallon build?
@DIYColdPlunge
11 ай бұрын
Thanks! And nope, same application 👍
@FIncognito1979
4 ай бұрын
Joe, what size hole do you cut if you want to install in stock tank?
@DIYColdPlunge
4 ай бұрын
If you are ordering the light from my site it is 2-1/8" for the light at 1-3/8" for the air switch
@marcmorgenstern1277
10 ай бұрын
Hi Joe - got everything hooked up and the light runs, but the switch doesn't control it. I hear a click on the switch, but nothing is happening with the light. Any idea what to look for on this?
@DIYColdPlunge
10 ай бұрын
Can you reply to your order confirmation email? I'll get you squared away
@jakeatkins8463
10 ай бұрын
Assuming probably not something to use for icebarell 300 setup unless plan on drilling holes?
@DIYColdPlunge
9 ай бұрын
Yeah I dont think that it will work for one of those.
@turtthewurt
Жыл бұрын
Would your entire DIY set up work in a spa like plunge with pool tiles rather than a a stock tub?
@DIYColdPlunge
Жыл бұрын
I think it would
@spenceruyleman3551
Жыл бұрын
I ordered one of these lights from your website and it’s not specified what size hole saw bit is required
@DIYColdPlunge
Жыл бұрын
Ah shoot! Hole for the light is 1-7/8" and the air switch is 1-3/8" for this light 👉diycoldplunge.com/products/multicolor-led-spa-light-diy-cold-plunge
@luke1the3duke
Жыл бұрын
@@DIYColdPlunge seems to be more of a 2” for the light bit.. no? Same predicament myself
@lukejessen8645
10 ай бұрын
@@luke1the3dukedid you end up using a 2in or 1 7/8 in hole saw for the LED light?
Пікірлер: 14