You need the Lee inline bullet feeder die on there.
@jawsmod
Жыл бұрын
Send me one. 🙂
@davespin9034
Жыл бұрын
I bought one of these. Great press and wonderful customer service from Lee. Watch the primer pin bore, its a cone so if you spill any powder stop because it'll seize up. A new bottom cover will allow spilt powder to drain so the primer pin won't seize. I think they will end up changing the carrier to fix the cone bore which is sisestable to seizing.. otherwise the press is solid. I've loaded a few hundred .223 so far. Another 500 waiting for time to do it.
@jawsmod
Жыл бұрын
I have the newer style bottom cover on mine.
@merlin1274
Жыл бұрын
Wipe a dryer sheet inside and out on that hopper and the powder won't stick to the sides. Can't wait to get one. Thanks for the vid.
@jawsmod
Жыл бұрын
It is titegroup powder. It is pretty sticky.
@The10thManRules
Жыл бұрын
I think this is the the Lee press to rule them all. Soon I plan on adding a DAA mini Mr. bullet feeder for rifle and pistol and a power check.
@tomislavjaranovic311
Жыл бұрын
Everything looks great....price
@jawsmod
Жыл бұрын
Street price is around $370 with dies
@JerrBearTactical
Жыл бұрын
Your bench looks solid as a rock ... why is there so much flex during press operation?
@jawsmod
Жыл бұрын
You are correct. A lot of it is in the Lee bench plate. I ended up taking the plate that mounts to the press off and then drilling holes thru the bench plate mounted to the bench top. So now I have holes that go thru the plate and then the workbench. It is really solid now!
@richpalmisano1740
Жыл бұрын
Lee seems to place ther mounting holes more towards the reloaded on most presses. The bench plate isnt the best. The aftermarket risers are solid, but like you I bolted my breech lock ap directly to the bench...I really like the looks of this press. Looks like they learned from the AP...
@keimolantio
Жыл бұрын
That bench plate sucks $ss
@cpd969
Жыл бұрын
Looks good untill 4:04. Do you really have to do that and why?
@jawsmod
Жыл бұрын
Yes. Sometimes they get jammed up and don’t want to enter the primer slide. I just do it to make sure they are feeding into the primer slide.
@StefanA357
Жыл бұрын
@@jawsmod There's a fix for that. But you probably know about that by now.
@1stFlyingeagle
Жыл бұрын
Make life easyer and get a powder check die. I bought the simple one. Just the bar going up and down.
Пікірлер: 17