Lesu got back to me saying the slower motor will eventually “break in” since the gearbox has a tighter tolerance than the other side.
@senyx0
2 жыл бұрын
Based on my experience, your best bet is to unscrew both motors from the brass body and compare them again. If one of them still jams, then disassemble the gearboxes and try the motors again. If it's one of the motors, then contact the seller. If it's not the motors, i.e. it's some jamming in the gearboxes, then try to swap some gears to find the one that fails, or it might resolve itself this way too. But most likely, your motor jams in the worm gearbox (the brass body), so simply try swapping the motors and slowing tightening the screws while constantly checking them. I had to do that stunt as well. Another thing that might apply to you as well... I had one motor replaced as a result. I couldn't get it to work with a dual motor driver (check the link I posted above) because it would just constantly trip over-current protection. I had a video chat with the seller, and the seller sent me another motor as a result. While the problem was greatly reduced, both motors would still get the over-current protection LED to blink sporadically. It left me wondering for some time... After some research (I actually ordered another pair of similar motors on eBay for testing), the conclusion was baffling - the commutator of these motors has a very bad design which makes them intermittently short the leads. In other words, the brushes are too thick for the commutator and they slightly overlap too much causing shorts at certain angles. This also leads to excessive battery drain obviously. I ended up removing the brushes and trimming them off slightly along the length. No issues so far.
@thatsmyrc
2 жыл бұрын
did you ever solve this issue? How do you like this unit overall? I have the Lt5H and I was wondering what replacement of esc's would work. I got the unit on a trade and the escs in it aren't the stock ones. Its currently running the hobby wing 1625. those esc's have a factory brake between forward and reverse. I dont care for that much and also both the drive motors seem to have 50% of the power in reverse. I have checked my end points on transmitter all is set all full end points.
@The-Warm-voice1359
2 жыл бұрын
Hello MR land How are ya.. Can you help me please be4 3 weeks ago i bought from Aliexpress lxyrc skit steer bobcat its work good even the pump But i have problem with the bucket i Can lower him And rise him by my hand even when i turn the pump on its same the oil in the tank is fine But i don't know why? if you knows i hope you help me thx 4 your reply advance she comes with radio FS I6S 10CH
Пікірлер: 4