Double Taper Sanding Disc: www.mikefarrington.com/dt-disc
In this video I build, paint and install a fireplace mantel. I show my various methods for building the structure. Then I dig deep into how I cut and install the various moldings, and I give a behind the scenes look at my spray finishing process. I also show a few of my favorite router bits and where I use them. Hopefully you enjoy the video.
Tip Jar... Patreon: / mikefarrington
Affiliate links. Using these links to purchase tools helps support this channel.
4" double square: lddy.no/nei1
Clamps I like, these fit in a dovetail slot or a 20mm dog hole: lddy.no/neht
My favorite all around table saw blade: lddy.no/olxq
I like this flip stop, I use it on my miter saw and table saw sled: lddy.no/oly0
Marking gauge: lddy.no/oly5
Air filter for spray gun: amzn.to/3lvUQKP
Replacement cartridge: amzn.to/32HmblS
Newer version of my spray gun: amzn.to/3ly7V6q
Pressure cup for spray gun: amzn.to/36vUPjL
Cabinet Coat paint: amzn.to/3f99jdn
Paint strainers: amzn.to/35sbC7L
Flush trim v groove router bit: amzn.to/2Up5hUt
Mini round over: amzn.to/32F56ck
Ogee for underside of top: amzn.to/3no6I20
Jig saw: amzn.to/32GBew5
Pin nailer: amzn.to/3lvEAt5
Miter clamps: amzn.to/3f1jFf1
Track saw: amzn.to/2YBDwdO
Biscuit joiner: amzn.to/34EwPvx
No 0 biscuits: amzn.to/3pvhwxg
No 20 biscuits, small pack: amzn.to/2Iy6Ixa
Drill and impact driver: amzn.to/32ufEdb
Glue: amzn.to/32AS5zo
Негізгі бет Lets Build a Fireplace Mantel, Paint Grade
Пікірлер: 1 М.