my bed and nuzzle are so far away when i turn the wheels they fall off
@stephenferguson3052
6 ай бұрын
Do you preheat your nozzle or bed before going through this process? If so, how long do you wait before beginning with the z offset?
@3dpathfinder
6 ай бұрын
The way that Elegoo advises is to do the manual bed leveling and then do the automatic bed level where the machine will heat up to 60°. I've tried both ways and there seems to be more inconsistency if I heat up the bed before doing the manual versus doing the manual while the bed is cold and then allowing the auto bed level to heat up on its own
@3dpathfinder
6 ай бұрын
I will say that I advise spending the most time on the manual bed level with the six points checking diagonally from say 1 to 4 then to two then to five and then going all around and get them as even as possible once I did that I've had no issues
Пікірлер: 4