This is part two or the drives side. On the passengers side, I sprayed onto a cloth and wiped down the seat after wiping with a mild soap and water. This time because the seat was a bit dirtier, I sprayed directly onto the seat and wiped it in and off, as WD-40 is a penetrating oil.
My seats are in good condition but the driver's side is dirtier and is worn a bit more than the passenger side. I have had the truck for about 4 years and have put about 70k miles on it. When I got the truck the seat covers were replaced. They are a leather vinyl mix.
Overall the process seemed to work well. As a cleaner and I was pleased with the result. My only concern is that it will ultimately dry out the seat. I don't think that it will, but I will watch and see. Here in AZ it gets pretty hot so I tend to condition the seats before, during and at the end of the summer with regular maintenance during the winter (dartlike and camping) months.
One last note... Just as a side note. I did wipe down the seat with a clean cloth when done, just to pick up any excess oils. Again, overall I was pretty happy with the results. My cloth was fairly dirty when done. So on that note... it seemed to work.
As always, if you got this far, thanks for watching and see the links below for cleaning and car care products. WD-40, Microfiber Cloths and Leather Conditioner... if you go that route. I have used all three products below and would recommend them.
Also use any and all products at your own risk. I have links below to products that I have used in the past.
Microfiber Cloths -
amzn.to/42DK0sr
WD-40 -
amzn.to/3UyRHOK
Leather / Vinyl Conditioner -
amzn.to/3HSVVcu
#wd40 #samsung #diy #leathercare #leather #vinyl #automobile #car #carcare #whatwouldyoudo #howdoi #autocare #ford #chevy #dodge #carcleaning #carcleaningproducts
Негізгі бет Life Hacks!!! - WD-40 Leather and Vinyl Care Part Two - DIY
Пікірлер: 2