I'm in the process of building a lifted 250es. I'm going to be running 32s. What kind of gear reduction would I need? Could you possibly help me out on knowing what I need?
@TheHondaOutlaw
Жыл бұрын
I would go with a pretty big one, the only problem is though when you get into a bind it will want to flip over backwards even when it is stretched. I still make reductions just not as often. 54 wouldn't really be enough but 88 would be plenty but again you will flip over a lot of not careful
@tennesseebackwoods8689
Жыл бұрын
@@TheHondaOutlaw thank you for the response! I will be looking into it
@junkrodgarage
6 жыл бұрын
What's the rear lift setup
@TheHondaOutlaw
6 жыл бұрын
what about it? its just a setup i made for it
@TheKelmo2828
6 жыл бұрын
Clutch kit or springs? Does it pop wheelies easier?
@TheHondaOutlaw
6 жыл бұрын
he put the actual clutch kit in it, not the springs for a higher stall, it did pop wheelies pretty easy on 28 zillas
@zacharylawrence839
6 жыл бұрын
How did you get After market rims to fit?
@TheHondaOutlaw
6 жыл бұрын
it helps if they are the same bolt pattern as stock
Пікірлер: 11